Aromamizer sup v3 play in juice and airflow rings

[Jd_]

Just trying to get this tank running without leaking.

I get a little bit of play in the seams between the rings. Its barely any, its a hairline of movement, pobably not even the width of a gasket, but can anyone else check theirs to see if thats normal?

 

[LordOdin]

Never had any problems with Leaking on any of my Aromamizers, it will leak if you fail or forget to close the Juice Flow when filling, other than that they fit in my list of Perfect Tanks.

 

[Jd_]

Never had any problems with Leaking on any of my Aromamizers, it will leak if you fail or forget to close the Juice Flow when filling, other than that they fit in my list of Perfect Tanks.

Yeah, but i am, seems like from the middle somewhere

 

[Jd_]

Im bored, so i guess today is a good day to tackle this one, since i have nothing to light on fire and blow up to celebrate.

I wasnt getting leaking from not closing the juice control (at least thats not what i was concerned about)
Where it seems to be coming from is in those rings, but only if i adjust them with juice in the tank. Thats why i was thinking oring seals, but then i noticed the play in the rings.

I dunno tho, maybe its inevitable that u get a slight seeping when u adjust the rings on it (i assume the only one in question could be the juiceflow ring, but i havent really taken it apart yet)

Thats what im about to do right now

(U know what, im looking at just the deck seal from the juice channel, and its not exactly new looking)

 

[Jd_]

Ok, so single coil deck out..i thought the seal was very thin compared to the postless deck (i shoulda taken a pic, that diff is quite obvious)

I put a new seal on the single coil, but it didnt look much diff once it was on so i put in the postless.

Turned off the juice, started filling, immediately realized i had turned the juice control the wrong direction, corrected that, finished filling, no leaking at all so far, even with the juice flow open (there might have been a little seepage, or possibly just from fingers)

Wiped it all up with iso so the is no trace of anything remotely greasy feeling.

Guess i will see how it goes.

Edit-did find a pic of the gaskets
Old one

New one

Postless deck (the seal is much thicker from the different channel it runs in)