BoxMod SXK Zero V2 50W Resin

[Vapaneezer Scrooge]

I have to be honest I have no idea if this is an original Boxmod or a clone so I am listing it as a clone.
It's a very quirky old school device, once in settings it's controlled by tilting the axis left or right.
Spec bumf below.

Condition 8/10 - very minor bottom marks and screwdriver marks on the screws.
RRP - No idea sorry, I can't find one available.

Price £15.00 + Postage (£3.95 Royal Mail 2nd Class signed for - or £4.45 1st class)
PayPal G&S

Photos of actual mod:

(tank not included - just to show the screen with a setup)

Specification:
510 threading connection with copper adjustable center pin;
Variable wattage: can be adjustable from 7.0W to 50.0W in 0.1 increments;
Tilt the mod leftward / rightward to adjust the output wattage;
0.8" LCD display;
Negative contact is adjustable;
Powered by 1 x 18650 battery (not included);

The normal coil resistance: 1.0 ohm. It will work when it reaches 0.2 ohm;
Shirt current: 4.2V <500uA;
Operating current: The maximum operating current is 18A when the coil resistance reaches 1 ohm;
Consistent power of input and output = +/- 0.5W, Maximum output (0.2 ohm): 3.3V (full charged);

Under consistent power:
Output error: +/- 0.5W;
Output power: 7~50W;
The device will match atomiser against accidental switching on to achieve consistently with the cloud;

Input operating voltage: 3.2V~4.2V of single battery (3.7V);

Coil resistance measurement, it will test real coil resistance of atomiser;

The device will display voltage, output voltage, coil resistance and output power;

In case of protecting the battery, the device has warming signal when the voltage is lower than setting voltage;

Functions of output short-circuit protection and low resistance protection, when the output is short circuit or with lower resistance, the device will be cut off;

When firing, the screen can display the battery, voltage, power and resistance. When the resistance is lower than 0.2 ohm, the screen will display LOW RES. No smoke out;

When the output end of atomizer is in the cutting-out situation, the screen will display SHORT;

When the voltage is lower than 3.0V, the screen will display Low-Bat after pressing the firing key;

Warming about the too high input voltage;

OLED screen display HHHHHHHH when the input voltage is higher than 5V, shows that cause the output voltage is too high no smoke out;

Battery voltage: single li-ion battery (full-charged) of 4.2V

 

[dahut]

@Crewella

 

[Crewella]

@Crewella

I have one, exactly the same. It's perfect for an MTL vaper and mine is still going strong.

 

[quincey43]

I have one too!! Exactly the same and I use it all the time, it's great and looks fab.

 

[eyeball kid]

These where lovely mods. If I wasn't drowning in mods I'd have been all over this.

 

[andyroo]

I’ve been looking at it all day, I give in, PM’d

 

[Ment]

I have to be honest I have no idea if this is an original Boxmod or a clone so I am listing it as a clone.

The SXK's were clones too, so this is another clone of the original Zero, which were in the region of £400.

 

[Vapaneezer Scrooge]

Sold

 

[deadmanvapes]

Damn saw this too late [emoji25][emoji25][emoji25]