Clone Dvarw MTL FL RTA Problem

["Misfit"]

OK it vapes great
The problem i have is when i refill
When i open it up, the plastic bit surounding the wick comes off,
meaning i have to rewick every time i refill.
How do you make sure the plastic suround stays in place when opening ?

 

[Crispycritters]

If it is held in place by an o-ring (I don't own this tank so I'm just guessing) maybe using a slightly thicker o-ring will sort it?

 

["Misfit"]

If it is held in place by an o-ring (I don't own this tank so I'm just guessing) maybe using a slightly thicker o-ring will sort it?

It seems the O ring at the top has a better grip than the o ring at the bottom.
Will look for a thicker o ring to try.

 

["Misfit"]

It works fine without the little o ring at the top
So far not leaking

 

[rj267]

Have a couple khw and a couple clones. Both clones i have ran into this issue and I had to replace with smaller o rings just like you.

 

[stuartd]

You shouldn't have to rewick everytime just take the metal peice of the top when you put the other piece back in and place the cotton were it needs tobe

 

["Misfit"]

You shouldn't have to rewick everytime just take the metal peice of the top when you put the other piece back in and place the cotton were it needs tobe

Was doing that but the wick started getting deformed,

 

[mattc1]

What clone company is it from. Wolf Coolvape by any chance? @Social Misfit

 

[smplmind]

I Have the one with 3xTanks from 3FVape, only used the 5ml tank with no problem but I will bear this issue with the small o-ring in mind if I have a problem with one of the other tanks.

 

[ChrisS]

Yikes. It's usually the chamber top cap that comes off when you refill rather than the plastic barrel. Playing with o-rings is just one of the things you sometimes have to do with dvarw clones.