Coil reading wrong on voopoo mod

[Andy Mcguigan]

Hi I'm running a 0.32Ω UN2 Single Coil in a Valyrian II 2 PRO Tank but the mod says the coil is at 0.28Ω . I was running the 0.14Ω UN2-2 Dual Coil before that and that sat at the 0.14 is this normal for it to be at 0.28Ω when it's supposed to be 0.32Ω?

 

[Crispycritters]

Hi I'm running a 0.32Ω UN2 Single Coil in a Valyrian II 2 PRO Tank but the mod says the coil is at 0.28Ω . I was running the 0.14Ω UN2-2 Dual Coil before that and that sat at the 0.14 is this normal for it to be at 0.28Ω when it's supposed to be 0.32Ω?

There is some variation with stock coil resistances - 0,32 to 0.28 is a little more than normal but I wouldn't worry too much as long as it vapes OK..

 

[Mr Ripple]

It's normal for coils to fluctuate slightly because the resistance alters slightly as the temperature of the wire material changes.

 

[Andy Mcguigan]

So it's just normal it sits at 0.28?

 

[Andy Mcguigan]

 

[Mr Ripple]

So it's just normal it sits at 0.28?

Press the fire button.
Does it change?

 

[Andy Mcguigan]

No just stays at 0.28

 

[Mr Ripple]

No just stays at 0.28

Have a toot on it does it vape okay?

 

[Andy Mcguigan]

Aye vapes perfectly fine at 100watt big clouds

 

[Crispycritters]

Nothing to worry about - its a bit lower in ohms than normal but stock coils are mass produced and there is often some variation.

If you get wildly different readings each time you fit the tank and the ohms jump about all over the place then you have reason to be concerned as it means there is a bad connection, but your coil is nothing to worry about.