Dead Rabbit V3 RTA Wick/Build Help

[TheVapingDinosaur1987]

I bought a Dead Rabbit V3 RTA today. However I'm getting no flavour. I'm cutting them at 5MM and I'm not thinning out the Cotton which is BP Cotton as watching some Videos they don't do that. Coils where Coils by Scott. Alien Claptons 0.14.

Second build is the same. Getting Coil detected then not the Next. I was Using the Coils in the Box.

Getting extremely frustrated.

Any advice please.

 

[JohnNada]

I don't have this RTA but if I was having similar issues with a tank try I'd try dropping the coils to 4.5 or 4mm if there's enough space. I'd also give the cotton a very light rake to help with wicking, then make sure it's snug but not too tightly packed in the juice wells.

I assume this isn't your 1st rebuildable and you know about dry burning at low power, saturating the cotton fully and stuff like that?

 

[TheVapingDinosaur1987]

I don't have this RTA but if I was having similar issues with a tank try I'd try dropping the coils to 4.5 or 4mm if there's enough space. I'd also give the cotton a very light rake to help with wicking, then make sure it's snug but not too tightly packed in the juice wells.

I assume this isn't your 1st rebuildable and you know about dry burning at low power, saturating the cotton fully and stuff like that?

Hello

This is my 6th RTA and I got annoyed with them. I thought I'd give it another go but same each time.

I do have a RDA which I've had no Problems with but got fed up with Dripping.

I don't think i can put the Coils below 5 as they will be too short and don't think I can tighten the legs on the deck.

I know to Pulse the Coils at low power and to saturate the Cotton Fully

 

[Deleted member 54254]

Build pics might help.

 

[mattc1]

Try less cotton, I would.

 

[RAPTOREX]

What @John R says.
We’re more likely to be able to help, if we can see what you’ve done.

 

[RichieRich]

Are you setting this up as Dual Coil? Total ohm reading coming out at 0.14?

I'll get some pics up later of how i've set up mine, hopefully it'll help. Not had any issues.

 

[TheVapingDinosaur1987]

I've sorted it now. Put in a Dual Build using Tri Core Claptons reading at 0.12 and thinned out the Cotton.

Thanks for the help.