Fogger V3

[Mrdazjones]

Just got a Fogger V3 yesterday, I've left the original mesh/coil setup in and for most of the time it vapes great, the problem is when I insert a fresh battery in my sentinal m16, I get very dry/burny throat hits until the battery loses a bit of power. Is this a problem with the coil, the mod or what? Any recommendations on how I can enjoy this atty to it's full potential?

Daz

 

[u8myufo]

how I can enjoy this atty to it's full potential?

Daz

Use a VV/VW

 

[Vape Geek]

Or remove the stock mesh/coil alltogether and make a new one by your preferences
Try to make it around 1.5-1.7ohm for a mech mod without a kick

 

[the jester]

looking forward to recieving mine

 

[Chegs]

I'm guessing your getting hotspots which cease once the battery has lost a little power.One of the problems with using the stock coil,suggest you rebuild it paying great deal of attention to the coil spacing & ensure it is fully contacting the wick.

 

[robteifi]

Either that or it's not wicking fast enough for the rate you're vaping

 

[Mrdazjones]

Thanks for all the replies, I'll have a go at re-coiling later today, may even attempt my first micro coil.

Daz

 

[KulrMeStoopid]

also, dont use freshly charged batts in a mech, take them off the charger for a couple hours then use them

 

[Mawsley]

Thanks for all the replies, I'll have a go at re-coiling later today, may even attempt my first micro coil.

Daz

Just done a review/how-to/shorting thing with pics here if you need it

 

[Soldier Blue]

Just done a review/how-to/shorting thing with pics here if you need it

Hiya Mawsley - do you know if the V3 has the same shorting problems that the v2 has ? Cheers - SB.