Harsh hits with Draco mod and falcon tank

[JordztheBrit]

Ok so new to this so I'll give as much info as I can I have the Falcon tank with the M2 coil and I recently got the modefined Draco mod but here's the issue I'm having after about two seconds the hit turns harsh or if I don't start puffing before I hit the fire button I've tried it on lower power settings then it's meant to go on higher settings I've tried different juices and everything but no no avail the only thing I can find that it could be is the resistance since it doesn't do it on my old mod but but for some reason it picks up the resistance at 0.13 on the old one (it's meant to be 0.16) but on the new one it changes between 14-16 and it's still harsh was wondering if there's any fixes or if I'm doing something wrong or what if you need any more info I'll gladly give it any advice is welcome at this point because I like the mod and the tank and don't wanna have to replace either

 

[Vapaneezer Scrooge]

Not sure why your ohms are out but it's not too far out, some can vary between mods, it's possible it's reading an old coil resistance, try removing the tank, press fire and a no atomiser message should come up, pop the tank back on and press fire and see if it asks if it's a new or old coil, select new.

The symptoms you're describing is the same as a coil at the end of it's life.

The M2 Mesh coils are absolute instant hit so it's best to draw before firing and after firing.

Just need a bit more info......

How old is the coil?
Does it do it on a new coil?
Have you been vaping below the minimum juice line on the coil?

 

[JordztheBrit]

Not sure why your ohms are out but it's not too far out, some can vary between mods, it's possible it's reading an old coil resistance, try removing the tank, press fire and a no atomiser message should come up, pop the tank back on and press fire and see if it asks if it's a new or old coil, select new.

The symptoms you're describing is the same as a coil at the end of it's life.

The M2 Mesh coils are absolute instant hit so it's best to draw before firing and after firing.

Just need a bit more info......

How old is the coil?
Does it do it on a new coil?
Have you been vaping below the minimum juice line on the coil?

The coil is only a few days old, I'm gonna be trying a new coil today so I'll let you know how that goes and never below the line I know thats one way to burn a coil out. I'll let you know how the new coil goes I just don't get why it does it sometimes and only on my new mod and not old one I'll try your fix

 

[Vapaneezer Scrooge]

With it behaving differently on 2 different mods, I suspect the settings on the 'dry hit' one needs tweaking, are you using normal VW (variable wattage) and preheat soft to normal and not Hard, also check you are not in temperature mode.

That's about all I can suggest for now.