Help & advice please!

[deb51]

Hi all, Need some help with getting my istick mello3 kit working again.Havve three of these & never had problems to start!The Mods are fine & work with a Mini Nautilus top BUT when I put the Mello3 (which came with mod on them comes up "no atomizer"...I live 200 klms from a Vape shop so no use going there...Anyone have any advice please?

 

[Arawn1975!]

Firstly welcome Deb!
Secondly 200km? !!! What the? What?

 

[Tazz]

Hi all, Need some help with getting my istick mello3 kit working again.Havve three of these & never had problems to start!The Mods are fine & work with a Mini Nautilus top BUT when I put the Mello3 (which came with mod on them comes up "no atomizer"...I live 200 klms from a Vape shop so no use going there...Anyone have any advice please?

Hi. Might not be it but first try these, get a tissue or something and give the 510 thread on the tank a good clean. I just hold it on the thread nice and firm and turn the tank around. Then do similar to the thread on the mod. Push the tissue into the hole and turn it a few times. Often thats all it takes.

 

[Tootlevape]

It could be that the aspire tank has a longer 510 connection than the melo and has pushed the 510 pin on the mod in so far that it is stuck and beyond the reach of the melo's 510.
Try using a small screwdriver or something similar to work your way around the mod's 510 pin, gently prising it upwards. This often does the trick.

 

[Martvb60]

Don't forget to take the battery out first (if it has an external battery) or turn the mod off, usually 5 clicks. Welcome to POTV

 

[Tootlevape]

Any update @deb51 ?

 

[gary68]

I found my wife's hastur mini goes too far into her istick pico threads and needs backing off half a turn.. I use the plastic of a milk bottle to fashion a washer and it works fine then

 

[nwhornet]

I found my wife's hastur mini goes too far into her istick pico threads and needs backing off half a turn.. I use the plastic of a milk bottle to fashion a washer and it works fine then

Attie gaskets from Stealthvape. Cheap & reusable. Great for stopping tanks scratching the top of mods too[emoji106]

 

[red5]

Earlier eleaf/joyetech/wismec mods are notorious for having a short 510 connector. As above use an atty gasket as described plus you have the added bonus that it reduces the chance of getting atty rash on top of your mods.

 

[MINEXPLORER]

Hi all, Need some help with getting my istick mello3 kit working again.Havve three of these & never had problems to start!The Mods are fine & work with a Mini Nautilus top BUT when I put the Mello3 (which came with mod on them comes up "no atomizer"...I live 200 klms from a Vape shop so no use going there...Anyone have any advice please?

try pulling the bottom off the coil an making sure the two coil legs are in contact with the center an shell of the coil.just like a light bulb the tip is the + and the case the is the - . sometimes badly assembled new coils just need a tweak to get them going.