Help Squape n duro

[SamuraiXtingo]

Need help disassembling squape n duro base deck
Suddenly it gives me check atomizer
I tried several mods and same results

 

[Rob]

The most likely cause of your problem is the Sleeve that the Screw in the 510 connection has failed. I had this happen with Both the N'Duro and an Arise that I purchased secondhand. The screw had been over tightened by the previous owner which split the Peek Collar.
StattQualm are VERY helpful and respond quickly to emails.

 

[SamuraiXtingo]

The most likely cause of your problem is the Sleeve that the Screw in the 510 connection has failed. I had this happen with Both the N'Duro and an Arise that I purchased secondhand. The screw had been over tightened by the previous owner which split the Peek Collar.
StattQualm are VERY helpful and respond quickly to emails.

Sorry what do you mean by the sleeve

 

[Rob]

There's an insulator that stops the Screw from shorting out inside the Threaded 510 connection. Only I now find that it is in fact an O Ring

Or just go for the Spares Pack

But in all honesty I would send them an email and describe your problem, they WILL help you out.

 

[SamuraiXtingo]

There's an insulator that stops the Screw from shorting out inside the Threaded 510 connection. Only I now find that it is in fact an O Ring

View attachment 345366 Or just go for the Spares Pack View attachment 345367

But in all honesty I would send them an email and describe your problem, they WILL help you out.

Thanks you mean I need to change the centerpin or the o ring

 

[Rob]

Probably start with the O Ring.