IGO W Problems

[mrHAIRYface]

Right firstly I just want to say the igo is really good, its been a good starting RDA for me but when I make my coils, insert the legs through the holes in the posts I have to be ever so careful not to snap the coil away, this kinda happens a lot and is majorly frustrating, I'm using .20 kanthal a1 wire. Secondly, hot legs, no I'm not talking about the ones on Kim kardashian, or the ones you buy from KFC, the ones I always seem to get in my dripper, the entire leg isn't all orange though there is probably half a mm not glowing when the wire is in the post, I say this but then I can't work out if its just a shadow being cast. Reason I'm bring this up now is I got my griegsters coil buddy through, made my perfect coil, then these hot legs came a lurking so I played with and ruined my perfect coil...but it still smokes when wick and juice are there and doesn't glow as the cotton wick touches all round, is this an issue if it doesn't glow when I wick it?

 

[u8myufo]

Sorry I cannot help, I bought a clone from FT. I got no holes I got no problems

 

[RicModMaker]

Adjust your wraps until they are no longer glowing

 

[mrHAIRYface]

'Adjust' define this term? Can push them up down left right in out and shake it all about?

 

[mrHAIRYface]

Hmm okay I see some people wrap the legs round the screws then tighten, can you do this? Admittedly I don't think I've seen people do it on the IGO-W

 

[clint]

I generally go through the hole of the centre post and around the screw on the negative.

 

[mrHAIRYface]

What's the reason for that?

 

[clint]

What's the reason for that?

It makes it easier to align the coil with the air hole.