multimeters

[jjl]

Hi
can any one tell me how to use my multimeter on my coils

 

[Tobes]

Hi there.

Set your multimeter to resistance test mode,typically denoted by the Ω symbol.

After you've built/fitted your coil,touch one probe anywhere you like on the metallic part of your atomiser......pretty much anywhere except the bottom centre of the part that screws into you battery.

Then put the other probe on the centre of the bottom circular part that makes contact with your battery. Make sure it doesn't come into contact with anything but this. Read result.

There are loads of youtube videos out there showing how to do this too. It can be a bit fiddly if you're not used to it,but you'll be doing it in seconds after a few goes :-)

 

[Yohoto]

Would it be very foolish to use something like the resistance check in a vamo in place of a multimeter?

 

[Tobes]

Would it be very foolish to use something like the resistance check in a vamo in place of a multimeter?

Ha ha!! :-) Good point! Absolutely not......assuming they've got one ;-)