Neeko 510 Insulator

[RichieRich]

Anyone know where i can get a 510 pin insulator for the Neeko ASAP?

Anyone got a knackered Neeko they could spare me the insulator from?

Lost it when cleaning the tank

Thanks in advance

 

[Mr Ripple]

Anyone know where i can get a 510 pin insulator for the Neeko ASAP?

Anyone got a knackered Neeko they could spare me the insulator from?

Lost it when cleaning the tank

Thanks in advance

The external measurements for these are the same and if I was a betting man.....
Can't guarantee of course but I'd take a punt if it were me based on the measurements.
https://www.fasttech.com/products/0/10021329/4616302-replacement-positive-post-insulator-for-plume

 

[RichieRich]

Thanks, won't fit unfortunately.

The Neekos insulator is like a cup, it sits between the 510 pin and the base.

 

[Mr Ripple]

Thanks, won't fit unfortunately.

The Neekos insulator is like a cup, it sits between the 510 pin and the base.

Yeah I'm aware of that I just measured mine.

 

[Mr Ripple]

Thanks, won't fit unfortunately.

The Neekos insulator is like a cup, it sits between the 510 pin and the base.

Here's a blown up picture for the single version.

https://www.fasttech.com/products/0...acement-base-post-insulator-for-plume-veil-v3

 

[Giurra]

Anyone know where i can get a 510 pin insulator for the Neeko ASAP?

Anyone got a knackered Neeko they could spare me the insulator from?

Lost it when cleaning the tank

Thanks in advance

Do you have access to 3d printer? This part looks relatively simple and i can measure it, design it in fusion 360 and send you the file for printing...

 

[RichieRich]

Do you have access to 3d printer? This part looks relatively simple and i can measure it, design it in fusion 360 and send you the file for printing...

Yeah i have 2 lol

 

[Giurra]

Cool, will design it and send you the file

 

[RichieRich]

Cool, will design it and send you the file

What a Gent! Thanks!

 

[Giurra]

@richierich no problem. It is simple to design. Took me 10 minutes to design and about 6 to print. Works for my Neeko. Mind you, every printer is different so there could be some dimensional differences but you can, if needed just slice it scaled. Used 0,12 mm layer height.