New aegis solo cerberus

[Vapingnewbie]

Hi again si I have gone for sub ohm and I have bought the aegis solo kit with cerberus tank 0.3 ohm coil 30-40 watts
I am looking for advice on settings etc like the tc mode and vpn etc
Also it came with a 2ml glass can u buy bigger glass or is it a case of new tank tia

 

[oORobOo]

Hiya, yeah you can get bubble glass for it, there is an extender for the chimney, see link below. TC and VPC modes will be dependent on what coils you are using.

https://www.ebay.co.uk/itm/273636846990

 

[DeeDee aka (Pod Queen)]

Also with this tank you can use so many other coils known as small coils. A few people i know use the vaporesso mesh or the ceramic coils. Hellbeast H1 coils are fab too.

Taken from the site:

Compatible Coil Notes:
These tanks are also compatible with Smok Baby Beast/Prince Baby coils, NRG GT coils, Ello HW coils, Wotofo Flow/Flow Pro coils.

 

[MrDJ]

most coils that come with tanks are for wattage mode only so stay away from setting it to TC temperature control.
TC can only be used with coils made from Ni200 nickel, Ti titanium. SS stailess steel can be used in both wattage and TC.

 

[Vapingnewbie]

Alot of info there lol yh the ones I got are super mesh 0.3 ohm so not sure if they are any good or not recommendations on which coils is gratefull thanks

 

[PaoloFio]

https://www.planetofthevapes.co.uk/...ssion/threads/geekvape-x1-vs-x2-coils.191764/

Could be worth reading this thread. Personally I prefer the x1 geekvape coils which are the 0.2 ones, better flavour IMO than the 0.3 x2. I've got the cerberus tank too, and have also used vaporesso nrg gt4 coils in it which have been good so far too. +1 on the bubble glass, the 2ml tpd one will need constant refilling. I've been recommended the vaporesso gt meshed, and HellVape H1 coils which I've yet to try, but with this tank you have alot of coil choices

 

[Vapingnewbie]

Ok thanks guys I've ordered the bubble glass so will be better and going have a look at these coils u guys have mentioned and get some ordered

1 more question if I may

The airflow is quite loose so I have reduced it a bit but I am wondering if I need to lower the wattage to compensate for loss of airflow or does it not matter

 

[oORobOo]

Ok thanks guys I've ordered the bubble glass so will be better and going have a look at these coils u guys have mentioned and get some ordered

1 more question if I may

The airflow is quite loose so I have reduced it a bit but I am wondering if I need to lower the wattage to compensate for loss of airflow or does it not matter

You're very welcome mate. Nah not really, the tank will get warmer faster because of the reduced airflow, isn't a problem the vast majority of the time but if you notice it getting hot you might want to lower the power or wait longer between puffs/sessions. People do tend to drop the power if they reduce the air flow but that's usually to keep the vapor at the thickness/temperature that they want or to reduce juice consumption.

 

[PaoloFio]

You may have to break the 2ml glass to get it off. Mine was stuck fast and in the end it cracked and mangled the top o-ring, so make sure you've got the bag of spare o-rings that should of come with the kit