Pulse bf fire button

[Vape lord]

Hi there guys. Just wanted to know whether this was normal. My pulse bf fire button spins around if I twist it. Is this normal?

 

[Tubbyengineer]

Not having one myself I can't be 100% sure but if it's a circular button with no indicator light then most likely yes it is normal - why bother to go to the extra expense of machining keyways to keep the button in one orientation if it doesn't need it. It will just be a circular actuator that presses on a physical switch underneath it...

 

[Vape lord]

Not having one myself I can't be 100% sure but if it's a circular button with no indicator light then most likely yes it is normal - why bother to go to the extra expense of machining keyways to keep the button in one orientation if it doesn't need it. It will just be a circular actuator that presses on a physical switch underneath it...

Ok and yeah you make a good point. Just noticed today that it has a bit of clicky movement from side to side but it isn't at any risk of getting stuck etc. Its a fully mech mod so doesn't have any indicator LED or anything and it is circular.

 

[Tubbyengineer]

Ok and yeah you make a good point. Just noticed today that it has a bit of clicky movement from side to side but it isn't at any risk of getting stuck etc. Its a fully mech mod so doesn't have any indicator switch or anything and it is circular.

OK, Just looked it up, it's a standard anti vandal type mechanical switch, the centre section will rotate if you try and judging by the design some lateral movement of the centre section is to be expected.
If the outer tapered ring section is moving then you'll need to tighten the big flat brass nut inside the mod that holds the switch in place - don't overdo it though since the body is plastic and too much pressure will crush or crack it...

 

[Vape lord]

OK, Just looked it up, it's a standard anti vandal type mechanical switch, the centre section will rotate if you try and judging by the design some lateral movement of the centre section is to be expected.
If the outer tapered ring section is moving then you'll need to tighten the big flat brass nut inside the mod that holds the switch in place - don't overdo it though since the body is plastic and too much pressure will crush or crack it...

Thanks so much mate. Really appreicate it and my mind is now at rest. If the outer ring ever starts to move then i shall do what you recommended