Question about rda's

[mrHAIRYface]

http://www.fasttech.com/products/1411/10005100/1431800 Right the IGO-W is a dual coil RDA and when you make 2 coils at 1.5ohm, when you work out the wattage on a vamo say, do you count them as a 3ohm resistance? And how hard is it to make it so the two coils don't touch? I think it may be a little harder on the IGO-L as on FT there's a picture of a coil either side and not inline like the IGO-W

 

[whit77]

2 x 1.5 ohm coils =0.7 ohm

 

[clint]

The resistance will half. So if you make 2 x 2ohm coils, the total resistance will be 1ohm. It's not much more difficult than the igo L. Maybe a little fiddly.

 

[mrHAIRYface]

Is that right? how can the resistance go down? So if what your saying is right 2 x 2.0 ohm coil = 1.0 ohm

 

[clint]

Is that right? how can the resistance go down? So if what your saying is right 2 x 2.0 ohm coil = 1.0 ohm

Correct.

 

[mrHAIRYface]

This makes no sense in my eyes of math lol 2 ÷ 2.0 ohm = 1.0 ohm makes sense

 

[whit77]

Ohms law

 

[clint]

Hence the name "resistance" The elecrical current is not as restricted.

 

[mrHAIRYface]

Okay so with two 1.5 coils would I be sub ohm vaping? And then with two coils I couldn't use it on a vamo as that only fires 1.5 ohm and above?

 

[clint]

Okay so with two 1.5 coils would I be sub ohm vaping? And then with two coils I couldn't use it on a vamo as that only fires 1.5 ohm and above?

That's right but the vamo has a 1.2ohm limit.