Rebuildable coils...

[mrHAIRYface]

Right I saw a video somewhere and it said when you wrap the coil the wire that ends up at the top has to always go through the centre post, so on an IGO W for example, the coil goes through the posts with the wire coning out the top through the centre post and the one on the bottom goes on the outer edge, cos it kinda confused me, and like when I dual coiled I was trying to figure out which way to put them in, basically is there a right way?

 

[big benson]

Pics would help pal.

 

[Phantom Diablo]

think that only refers to when making vertical coils in things like RSST simply because the negative post is a screw at the bottom of the atty and the centre postive post is higher up. if you look at some drippers you may also see that if it has post holes sometimes the positive post hole is slightly higher so makes sense to use the top wire to connect. really other than that no reason why its just how they seem to be set up

 

[u8myufo]

If I am right I think you are on about mirroring your coils. Leg of coil A comes over the top, the leg of coil B which comes over the top gets connected into the same terminal post. Same applies for the legs which come out from the bottom of the coil.

 

[clint]

If I am right I think you are on about mirroring your coils. Leg of coil A comes over the top, the leg of coil B which comes over the top gets connected into the same terminal post. Same applies for the legs which come out from the bottom of the coil.

Yeah, you'd wrap one clockwise and one anticlockwise so to speak.

 

[clint]

I do that on my igo w sometimes, I put 2 coils on 1 wick on the same side. So one coil gets wound opposite to the other.