MetalVape90
Achiever
- Joined
- Jan 17, 2019
- Messages
- 2,440
The Rincoe Manto AIO, a single 18650 80W all in one device.
The pod holds up to 3ml of juice, you get a choice of a 0.3 ohm mesh coil, 1.2 ohm regular round wire coil and an RBA section. You also get 2 drip tips, 1 for MTL and one for DTL already on the device.
Specifications:
Power: 5 to 80W
Voltage: 0 to 8V
Efficiency: 90-95%
Hit: Semi-restrictive DTL and MTL
Settings: Bypass, Temp (Ni200, SS, Ti), Stealth and locking power
Material: Zinc Alloy
Patterns: Snake Man, Raijin, Carbon fibre and there should be more.
Note:
The airflow is on the spine of the device instead of the panels like the Billets.
Cons (might be subjective):
The device hums when active but it isn’t concerning. You may notice the hum if you it’s quiet enough place.
The threading on the RBA are crunchy and the screws may not clamp down on your coil hard enough allowing the coil to move slightly when fitting (this might be cause I’m using regular 24 gauge wire) and the amount of space available is too small for certain coils.
Edit:
Comparing the Rincoe Manto AIO to the Zeta AIO by Think Vape.
The Think Vape Zeta AIO 60W is slightly more compact, more restrictive on the airflow, heavier than the Rincoe and slightly more boxier (not as rounded) than the Zeta AIO.
Note:
This review is subjected to change as I am currently testing it.
The pod holds up to 3ml of juice, you get a choice of a 0.3 ohm mesh coil, 1.2 ohm regular round wire coil and an RBA section. You also get 2 drip tips, 1 for MTL and one for DTL already on the device.
Specifications:
Power: 5 to 80W
Voltage: 0 to 8V
Efficiency: 90-95%
Hit: Semi-restrictive DTL and MTL
Settings: Bypass, Temp (Ni200, SS, Ti), Stealth and locking power
Material: Zinc Alloy
Patterns: Snake Man, Raijin, Carbon fibre and there should be more.
Note:
The airflow is on the spine of the device instead of the panels like the Billets.
Cons (might be subjective):
The device hums when active but it isn’t concerning. You may notice the hum if you it’s quiet enough place.
The threading on the RBA are crunchy and the screws may not clamp down on your coil hard enough allowing the coil to move slightly when fitting (this might be cause I’m using regular 24 gauge wire) and the amount of space available is too small for certain coils.
Edit:
Comparing the Rincoe Manto AIO to the Zeta AIO by Think Vape.
The Think Vape Zeta AIO 60W is slightly more compact, more restrictive on the airflow, heavier than the Rincoe and slightly more boxier (not as rounded) than the Zeta AIO.
Note:
This review is subjected to change as I am currently testing it.
Last edited: