Silicone stopper/bung 2mm diameter

[Ssscrudddy]

Hi, Im not sure of the best place to put this, so I thought I'd try here.

Anyway I'm looking for somewhere to get some Silicone stoppers/bungs 2mm diameter

I have an AgaT+, It has some screw holes on top.

1 is used for the ss mesh wick (without a screw in it).
1 is used for the screw to hold 1 end of the coil wire (with a screw in it)
1 is used as the filling hole (with a screw in it)
1 is used with a push in thingy for using a silica wick (with an even smaller screw in on top of the push in thing)

All these holes are the same size. I'm guessing they are 2mm but I dont know (based on drill bit method for coiling a Cobra, says 2mm)

So what I'm looking for is a silicone bung, to replace the screw for the filling hole. I dont want to carry a screwdriver around with me, & if I'm out all day I want to be able to refill my juice (with a needle bottle)

Anyone know where I can get some of these please? I have seen a rebuildable of this style with a silicone bung for the filler hole, but I cant remember what it was or where I saw it.

 

[KulrMeStoopid]

not sure where you could get one specially made... but you could make one?


Sounds a bit daft but you could fill the hole with silicone, let it set and then just push the needle through it shouldn't pop out that way until its spent and needs replacing. You could also let a lil ball of silicone dry, then cut it to size with a craft knife and fit it tightly.

 

[Purplefowler]

I don't bother with the filling screw, it seems to wick better and I always keep it upright so leaking isn't a problem.

 

[stealthvape]

How about cutting one of these in two?
http://www.ebay.co.uk/itm/2mm-Silic...Jewellery_Rings_SR&hash=item3a56e25b8c&_uhb=1

 

[ocd13]

How about cutting one of these in two?
http://www.ebay.co.uk/itm/2mm-Silic...Jewellery_Rings_SR&hash=item3a56e25b8c&_uhb=1

Looking at the description they call it a tunnel so I presume they are hollow so would be no good.
Saying that you could possibly use one of those with sort of pin inside it to seal the hole but still be much easier and quicker to remove than a screw

 

[Ssscrudddy]

Thanks for the suggestions peeps. I'm not sure about the ear tunnel/plug, at the top it says plug but in the description it says tunnel(=hollow). I will say if that's 2mm in the middle, I've not seen 1 that long. But if its a plug that would work.
I have found a place that does tapered "stoppers", £1.20 each min order 10, seems a bit pricey for what they are. Also they are a bit long but could be cut down. I've also found a place that does something similar, much less per unit, but min order 250 = same money to spend.

I have a 10mm ear hole myself done before it was the fashion to do such things. My collection of 10mm ear plugs.