What's new

Squonk newbie question

jj87

Postman
Joined
Dec 16, 2015
Messages
794
Hi I am new to using a squonk set up & have a question...

Can I use my normal strength of 12mg juice on my squonker? Hope so as I have a few litres of juice at that strength. I haven't tried as I'm waiting for my new mod to turn up. Cheers
 
It depends on what build your using really buddy not the fact your squonking... SubOhming 12mg might rip the back of your throat out. Generally 6mg max is suggested if your going to build low...
 
^ what Jerry said, the fact that your squonking your juice makes no difference
the atty/build does [emoji106]
 
Hi I am new to using a squonk set up & have a question...

Can I use my normal strength of 12mg juice on my squonker? Hope so as I have a few litres of juice at that strength. I haven't tried as I'm waiting for my new mod to turn up. Cheers
I tend to build the same coil in my narda/origen 16 or o atty as I would in the kaufun mini v3 or rose v3. A kanthal or nichrome single 2.5mm coil at about 1.2 ohms. That way I can use the same juice and nic strength.
 
Hi I am new to using a squonk set up & have a question...

Can I use my normal strength of 12mg juice on my squonker? Hope so as I have a few litres of juice at that strength. I haven't tried as I'm waiting for my new mod to turn up. Cheers

I think it might depend on your ratio of PG/VG as much as your nic strength, I normally vape 18mg in my KFL MTL, and use a maximum of 12 for dripping/DTL, but I MTL 60pg/40vg and use a minimum 50/50 for DTL.

With some of the BF RDAs you can run them for MTL, so you should be able to use whatever jucie you like..
 
Back
Top Bottom