Billet storage

[Vapaneezer Scrooge]

Printed and not quite secure enough, a few changes and I think I've nailed it with this one, 6 hour frikking print though, looks better with the BB's and tips on it.

 

[Vapaneezer Scrooge]

Tweaked a few more dimensions but still needs a couple of more tweaks, it's fine for me as it is but I want less forward rocking if I'm going to sell any.

Any interest before and suggested improvements I spend more time?

Production ones will be BLACK.

 

[MavicP]

Definitely interested in one, but, and maybe its too late for this tweak, that corner behind the BB's is maybe a handy area for a spare Boro to sit, if it wasn't sniped off as per the photos...?
Either way, I'll have one Si...

 

[Vapaneezer Scrooge]

Definitely interested in one, but, and maybe its too late for this tweak, that corner behind the BB's is maybe a handy area for a spare Boro to sit, if it wasn't sniped off as per the photos...?
Either way, I'll have one Si...

It wouldn't take me long to add Boro slots behind, in fact I'm up for one of those so I will do 2 versions, there was room for more drip tips but it started to look cluttered.

As it 'stands' I had to make it loose enough to hold thicker panels but can't make it tight to avoid scraping, I was thinking of adding a central tab, maybe a letter B on each one?

 

[MavicP]

It wouldn't take me long to add Boro slots behind, in fact I'm up for one of those so I will do 2 versions, there was room for more drip tips but it started to look cluttered.

As it 'stands' I had to make it loose enough to hold thicker panels but can't make it tight to avoid scraping, I was thinking of adding a central tab, maybe a letter B on each one?

As the proud owner of gel panels, I get that. I might put a bit of felt in whatever I get, does two things, makes it a bit tighter and stops the scratching issue...?
Centre tab sounds good also...

 

[Vapaneezer Scrooge]

The tab should solve it, it's only to stop it being knocked over, when I tested it the back was fine but a knock forward it would nearly fall over so I just wanted to add some extra protection, it shouldn't need felt lining, Resin is reasonably hard wearing, people use it for mug coasters etc.

 

[Vapaneezer Scrooge]

After much over engineering, here is the version with rear Boro Storage and more symmetry:

Print time now.........

 

[Vapaneezer Scrooge]

This version worked out a treat, no more tipping of BB's with custom 3mm panels, Boro's fit perfectly and out of view, Ithanks for the inspiration MavicP