BP mods sure mtl rta

[zouzounaki]

this is why i was skeptical about it having the air hole in the bottom. side holes seems to make more sense. but we’ll see, miby i’ll like it.

 

[Netvaper]

deleted

 

[zouzounaki]

so this arrived this morning from @jimmy_sparks . thanks mate!

first impression is it’s a bit complicated. couldn’t get my head round it. i think i have it working now, but had to put a big 3mm coil in it, couldn’t find the 2.5mm drill bit and it seems it will flood if i use my usual 2mm.

it’s a smooth draw, i will give it that. let’s see if i remember which way to turn the fucker and whether to push it down or force it depending on why i’m turning it.

 

[Phrasing]

so this arrived this morning from @jimmy_sparks . thanks mate!

first impression is it’s a bit complicated. couldn’t get my head round it. i think i have it working now, but had to put a big 3mm coil in it, couldn’t find the 2.5mm drill bit and it seems it will flood if i use my usual 2mm.

it’s a smooth draw, i will give it that. let’s see if i remember which way to turn the fucker and whether to push it down or force it depending on why i’m turning it.

The notches can be a pain but it's worth it if you stick with it.

 

[zouzounaki]

it’s playing havoc with my mila air purifier. every time i have a few puffs the aqi jumps to 100 +. i gave it a wee clean before i put a build in it, so who knows what’s going on. the daft thing has it’s fan on full pelt, was hoping to get a sleep before i need to go out and pick up my wife and the wee one, as well. eurgh.

 

[Rickster]

so this arrived this morning from @jimmy_sparks . thanks mate!

first impression is it’s a bit complicated. couldn’t get my head round it. i think i have it working now, but had to put a big 3mm coil in it, couldn’t find the 2.5mm drill bit and it seems it will flood if i use my usual 2mm.

it’s a smooth draw, i will give it that. let’s see if i remember which way to turn the fucker and whether to push it down or force it depending on why i’m turning it.

I never have the juice control off...... so it's simply a matter of turning the tank n mod upside down , line up the notch, push down n a quarter turn clockwise
push down and turn a quarter anti clock wise to remove.,

 

[zouzounaki]

i’ve put a wee coil in it, doesn’t seem to be flooding.

 

[zouzounaki]

it’s still fkin up the air. four puffs and she’s going mental again. last time this happened was when somebody farted near it.

 

[jimmy_sparks]

so this arrived this morning from @jimmy_sparks . thanks mate!

first impression is it’s a bit complicated. couldn’t get my head round it. i think i have it working now, but had to put a big 3mm coil in it, couldn’t find the 2.5mm drill bit and it seems it will flood if i use my usual 2mm.

it’s a smooth draw, i will give it that. let’s see if i remember which way to turn the fucker and whether to push it down or force it depending on why i’m turning it.

no worries mate! Hopefully you get some good mileage out of it.

 

[zouzounaki]

so after a couple of hours, i’m quite impressed with this. it’s decent. it’s not flooded or threatened to leak even with the wee 2mm coil and the air fully open. the narrow tip is very good.

and it’s super smooth and quiet, almost close to the bishop in that respect. the 0.8 insert might even be too tight, i may switch it for a slightly bigger one.