Damn Vape Atemporal RBA

[LordOdin]

Got the Atemporal with the Nitrous AIO Kit and only used it once. I found the AIO to be very heavy on Batteries and seemed to eat Power even in Stand-By. I haven't used it since just before my Stroke so it still had liquid in it from over 12 Months ago. Anyway Sophie has been putting my RBA's through the Ultrasonic and this morning came to me with a confused look on her face. She managed to remove the Top and took out the Cotton but Couldn't figure out how to remove the Coil, Liquid or the Mesh Wicking Strips. I remembered how to remove the Coils so showed her that but stuck with the Mesh and Old Liquid sat in it. Can't see anyway of opening it any further. Only thing i could think of was standing it upside down in the Sink to try and get the Liquid out but still Puzzled with the Mesh. Anyone know anything about these RBA's that can advise. Thanks in advance.

 

[Moses]

Got the Atemporal with the Nitrous AIO Kit and only used it once. I found the AIO to be very heavy on Batteries and seemed to eat Power even in Stand-By. I haven't used it since just before my Stroke so it still had liquid in it from over 12 Months ago. Anyway Sophie has been putting my RBA's through the Ultrasonic and this morning came to me with a confused look on her face. She managed to remove the Top and took out the Cotton but Couldn't figure out how to remove the Coil, Liquid ot the Mesh Wicking Strips. I remembered how to remove the Coils so showed her that but stuck with the Mesh and Old Liquid sat in it. Can't see anyway of opening it any further. Only thing i could think of was standing it upside down in the Sink to try and get the Liquid out but still Puzzled with the Mesh. Anyone know anything about these RBA's that can advise. Thanks in advance.

You can get some tweezers and pull the mesh wick out and tip it at a angle and all the juice will come out. But there is also a way to take it fully apart. I believe you need to unscrew from the 510 pin and then there's some little silver screws inside under the coil I think.

 

[LordOdin]

You can get some tweezers and pull the mesh wick out and tip it at a angle and all the juice will come out. But there is also a way to take it fully apart. I believe you need to unscrew from the 510 pin and then there's some little silver screws inside under the coil I think.

Will have another Look. Mesh Holes look a bit small for Tweezers but will have a go. Thanks.

 

[Moses]

Will have another Look. Mesh Holes look a bit small for Tweezers but will have a go. Thanks.

Some needle nose tweezers will pull the mesh wick out.

 

[LordOdin]

Some needle nose tweezers will pull the mesh wick out.

You were right about the Tweezers and the Mesh, i got it out, there are no Screws at the bottom like you said though. Looks Sealed. Sophie moved the little slider covering the Juice Fill Port and the Liquid Came out of that. I had forgot about that Slider. All rinsed out now. Need to find somewhere that Sells the Wicking Mesh now.
Thanks for the help @Moses it's much appreciated.

 

[Moses]

You were right about the Tweezers and the Mesh, i got it out, there are no Screws at the bottom like you said though. Looks Sealed. Sophie moved the little slider covering the Juice Fill Port and the Liquid Came out of that. I had forgot about that Slider. All rinsed out now. Need to find somewhere that Sells the Wicking Mesh now.
Thanks for the help @Moses it's much appreciated.

You can reuse the mesh that it came with. Or if you have the original case it came in I believe there may be some spares in there. Just rinse the current ones out in some hot water and then re roll them and stick them back in and they should be as good as new.

 

[LordOdin]

You can reuse the mesh that it came with. Or if you have the original case it came in I believe there may be some spares in there. Just rinse the current ones out in some hot water and then re roll them and stick them back in and they should be as good as new.

You are right again. The Atemporal came in a seperate box which Sophie found earlier on, it had some wicking mesh inside plus an allen key for it. I have put the Mesh that was in the Atemporal through a Hot Ultrasonic Bath and it does look pretty good and even kept it's shape. I am looking through the Online Stores for some more RBA's, i have really got into them again.