Dead rabbit rda help

[Coledavis21891]

Ok I have a dead rabit rda every few puffs it asks if its a new coil it also does this with my zeus sub ohm tank but works fine with my other tanks most of the time I cleaned my 510 pins and it still does this the mod is a aegis legend what would cause this

 

[Mr_Fog]

Try tightening the post screws and/or 510 connection, could be the ohm reading from the coils fluctuating too much. What material are the coils?

 

[Crispycritters]

Try tightening the post screws and/or 510 connection, could be the ohm reading from the coils fluctuating too much. What material are the coils?

^This

I've had similar problems with a few attys and the cause has normally been a slightly loose screw somewhere...

It would be a good idea to totally strip the tank down and give it a good clean (including the post screws) as sometimes juice can get in and leave a baked on layer of gunk which can cause similar problems.

 

[Crispycritters]

With the Zeus sub ohm tank - strip and clean. Make sure the tabs on the side of the coil (the negative contact) and the areas they contact when pressed into position are scrupulously clean. The bottom metal area of the coil is the positive contact - this should also be clean. Check the screw-on base of the tank and make sure the internal area of the 510 is clean.

Re-assemble the tank and make sure the base is tightened properly so the coil makes good connection. Hopefully this will sort it

 

[Coledavis21891]

Try tightening the post screws and/or 510 connection, could be the ohm reading from the coils fluctuating too much. What material are the coils?

They are ni80

 

[Coledavis21891]

Thanks everyone