Dna250 first attempt

[jock1092]

So after a painful week getting this mod ready, I gave up on the original plan and grabbed a Stealthvape pre drilled case
This is my first time setting up a regulated mod or using a lipo
Went for a turnigy nano 950mah 25-50c, mm 510 and nls-g3.3 enclosure

One wire from the lipo ended a bit short as the build is going in a tighter enclosure at some point, that's if I ever get my faceplate right.

Got an escribe question though, 28amp is a bit on the high side for this pack from what I've read, can I limit the max draw on the board via escribe or would capping the wattage be more effective?
Not that I expect to be Vaping that high but never a bad idea to put the right safety in place

 

[mattvapes1976]

Great first job !

 

[WaitFor1t88]

you can limit the wattage in escribe, I know that, not sure on amp limit though

nice job mate

 

[jock1092]

you can limit the wattage in escribe, I know that, not sure on amp limit though

nice job mate

Right I'll have to find that then, suppose it doesn't really make much difference as get will both put a cap on what amps I can draw
I think escribe is going end up as much work as the mod

 

[jock1092]

Great first job !

It's been something I've wanting to build since I started making mods, made a handful of mosfet boxes and simple builds but never felt ready to work on a regulated mod
Great feeling finally getting one right though

 

[WaitFor1t88]

Right I'll have to find that then, suppose it doesn't really make much difference as get will both put a cap on what amps I can draw
I think escribe is going end up as much work as the mod

its where you put the battery settings , in the mod/power tab on escribe, soz I cant be more specific, been a while since I've used escribe, make sure you have manufacture/advanced setting checked in the tools/settings section (again apologies if thats the wrong place to find it)

 

[vapesmarter]

keep at it looking good

 

[andy3434]

Right I'll have to find that then, suppose it doesn't really make much difference as get will both put a cap on what amps I can draw
I think escribe is going end up as much work as the mod

if under options you set the interface to manufacturer in the mod tab you can set amps limit

 

[Tubbyengineer]

That battery pack is rated for 25 - 50c, giving a Discharge rating of 950*25 or 23.75 amps for continuos and 950*50 or 47.5 amps for pulsed discharge, 30 amps should be no great shakes for that kind of battery - but at full tilt it won't last very long...

 

[jock1092]

That battery pack is rated for 25 - 50c, giving a Discharge rating of 950*25 or 23.75 amps for continuos and 950*50 or 47.5 amps for pulsed discharge, 30 amps should be no great shakes for that kind of battery - but at full tilt it won't last very long...

Yeah I picked it for a smaller enclosure than this one, but just not managed to get it ready yet, but it lasts better than I expected it.
As for the amps Im usually just a bit over cautious