Enclosures

[Chegs]

I use Hammond enclosures from China(via eBay as they're under £4 each)and lipo cells from hobbyking.co.uk (about £1.60 each)for 1000 mah cell, which are easily connected in parallel to get a 4000 mah pack, and to charge them I use a USB PCB with 1 amp output, takes a while to charge the pack but gets me 30 odd hours of 0.3 ohm vaping. If you used the sx350 board, then you'd get much longer usage from the lipo pack. The sx350 and lipo cells would fit within the Hammond enclosure easily, as you're wanting the sx350 then the box has to be larger than your vapourshark unfortunately.

Sent from my SM-T210 using Planet of the Vapes mobile app

 

[Mawsley]

To say that I am disappointed I can't rant in this thread about the theft of common land from the people, robbing and placing it the hands the rich elite, is an understatement.

 

[Raguri]

To say that I am disappointed I can't rant in this thread about the theft of common land from the people, robbing and placing it the hands the rich elite, is an understatement.

Oh but you can. The Hammond boxes chegs uses are... -whispers- ... clones.

 

[RicModMaker]

To say that I am disappointed I can't rant in this thread about the theft of common land from the people, robbing and placing it the hands the rich elite, is an understatement.

Go on Dave, I love a good rant. I dare you. Don't get Sam going though or hell be on the naughty step again ;-)

 

[Mawsley]

Go on Dave, I love a good rant. I dare you. Don't get Sam going though or hell be on the naughty step again ;-)

Bring back the open field system and fuck the 12th Century monarchy.

And the 16th century Parliament.

And all monarchy.

And all parliaments.

 

[RicModMaker]

Just bring back the Sex Pistols!

 

[Bigwhiterabbitt]

Has anyone managed to find a small suitable enclosure like the Hammonds that "don't" have tapered sides?

 

[RicModMaker]

Has anyone managed to find a small suitable enclosure like the Hammonds that "don't" have tapered sides?

Nope. I'm guessing that any low cost die cast enclosure would have a small taper or it will be harder to get off the die. Anyone else?

 

[gary1968]

Yeah, all castings / moldings will have a 'draft angle'to allow them off the tooling.

Sent from my HUAWEI U8815 using Planet of the Vapes mobile app

 

[Bigwhiterabbitt]

That explains it. Didn't know that, thanks guys..