First real go

[mdhardy01]

Ok just tried my first proper sub ohm
Parallel 0.4 kanthal round a 2mm drill bit dual coil in a tobh 26650
OMG almost instant heat up and even 6mg hurts comes in at 0.16ohm

Sent from my iPhone using Planet of the Vapes

 

[Chegs]

More air needed

posted by an unauthorised idiot

 

[mdhardy01]

More air needed

posted by an unauthorised idiot

But the tobh 26650 has huge air holes
They are about 1.5mm each so that would give 4.5mm per coil ??



Sent from my iPhone using Planet of the Vapes

 

[gords1001]

You definitely need more air, my tobh didn't even get a build in it before it was drilled, both posts and top cap

 

[mdhardy01]

You definitely need more air, my tobh didn't even get a build in it before it was drilled, both posts and top cap

@gords
Are they all 26650? If so what is the middle mod?


Sent from my iPhone using Planet of the Vapes

 

[gords1001]

All 18650. Middle one is the fortune ob18650, though apparently its not sub ohm capable, the .2ohm build thats been in it for months may beg to differ lol.

 

[Raguri]

All 18650. Middle one is the fortune ob18650, though apparently its not sub ohm capable, the .2ohm build thats been in it for months may beg to differ lol.

Sub ohm - Sure.
Super sub ohm - Wouldn't... Anything that contacts on side wall, I wouldn't...

 

[StuPot]

Sub ohm - Sure.
Super sub ohm - Wouldn't... Anything that contacts on side wall, I wouldn't...

But what's super sub ohm? I've had it at .17 without issues. How low do you think is too low for it?

 

[Raguri]

But what's super sub ohm? I've had it at .17 without issues. How low do you think is too low for it?

Sub 0.1 . Mainly due to Heat + Fully magnetic switch + Sidewall = Sparks from my experience

 

[gords1001]

I'm leaving it up at .2ohm. It works well there, why break it?