Fogger v4.1

[bozzer89]

So finally received my fogger v4.1 and wanting to put it on my sting Ray but 1st of all I'm using a 18350 battery just until I order mine and I'm using a multimeter to check the ohms until I receive my ohm meter through so how do I use it to check what ohms it is ??

 

[bozzer89]

That's what I'm using

 

[blademansw]

Set your multimeter to the 200 Ohm range. Then firmly place one probe on the screw section of the 510 connector, and firmly press the other probe into the positive pin of the 510 connector. Job done.

 

[Rob]

Spin the dial round to ohm and set at 200. Put the Red probe on the 510 centre pin and the Black probe on the threaded section of the 510 and there ya go.

 

[Rob]

Our internet connection is so slow today..... waited about 2 minutes for that to appear. Still, better than yesterday, NO internet connection.

 

[bozzer89]

So red on the middle black on the outside ( thread ) ?

 

[StuPot]

So red on the middle black on the outside ( thread ) ?

That's right. Although I suspect it'll be the work either way.

 

[bozzer89]

Set your multimeter to the 200 Ohm range. Then firmly place one probe on the screw section of the 510 connector, and firmly press the other probe into the positive pin of the 510 connector. Job done.

Spin the dial round to ohm and set at 200. Put the Red probe on the 510 centre pin and the Black probe on the threaded section of the 510 and there ya go.

It's reading 06.8 ?

 

[bozzer89]

08.9 now

 

[bozzer89]

So basically it's about 0.6 - 0.9 so its sub ohm yes?