What's new

Genesis problem

Sounds like your mesh has got a rough edge under the coil causing it to evaporate the juice & then burn away the coil.I was told to try a washer on the centre + post,this worked well but was a twat to build coils with.Are you pulsing the coil to bed it on the mesh,you must slowly heat the coil and you should see the red area gradually creep along with each pulse until the whole coil is going red.BTW,3 turns is very low ohms(I know you'll know this)so the coil will need a little tweaking/nursing to get it to heat evenly initially.
 
I'll try more coils and less mesh and Il tweak and pulse cheers fellas Il let u know how I get on later

Sent from my HTC One X using Planet of the Vapes mobile app
 
I think others have cracked it for you.

I'd imagine three wraps would produce a very low resistance, increase your resistance (more wraps) decrease the amount of wicking material use and you'll probably be rocking and rolling.
 
It's much better now still not perfect yet though the flavour seems a bit muted I'm getting there though I used a smaller piece of mesh with 6 wraps of .30 kanthal got it all bedded in and glowing evenly and no glowing when there's juice so nearly good

Sent from my HTC One X using Planet of the Vapes mobile app
 
Thanks again fellas

Sent from my HTC One X using Planet of the Vapes mobile app

No probs. Glad you got there. There are so many people moaning about Genny attys when I think they are the best design. Flooding versus dry hits seems to be an age old discussion. Wicked right, gennys are perfect.

Sent from somewhere in Kent.
www.vapechat.co.uk - Vaping chat room
 
I'm not quite there yet Il keep tinkering away and I'll get there with it

Sent from my HTC One X using Planet of the Vapes mobile app
 
I love my gennys,3 to 1 dripper.They can be a pig to setup,but once you get it sorted,piece of piss thereafter.
 
Back
Top Bottom