What's new

Griffin tank flooding advice req

mrgee

Initiate
Joined
Aug 17, 2015
Messages
29
I have a griffin tank its my first rta and sorta getting the wicking right but have an issue that i cant sort out, basically if i hold the device and use i normal position its fine for a few draws then if i flick the device 45 degrees a bit of juice flicks out of mouthpiece. Then its ok for few more draws then its flick juice out agai . Not sure if it flooding or what. Anyideas anyone?
 
Have you tried switching it on and off again?










Seriously though....try closing the juice control a little...and see if that helps
 
I ve tried closing juice holes and makes no difference. The juice that flicks out is warm
But then why should i need close the juice holes? Isnt it supposed to work fine fully open anyway?
 
I ve tried closing juice holes and makes no difference. The juice that flicks out is warm
But then why should i need close the juice holes? Isnt it supposed to work fine fully open anyway?
You can flood the chamber and that's what could be causing the juice to find its way into your mouthpiece...it could also depend on what % ratio of vg your running...I use max VG Which if guess is around 90% so the juice is thick...
 
My juice is 70/30vg.pg. Jusy ca t stop this floding if that what it is
 
7 wrap parallel 26 gauge 3mm id giving me just over 5ohm vaping at 30 watt,

As for cotton am putting more than I have been doing thinking I may not be using enough,
 
You need to pack the wick, if you think you have enough, you don't, use some more, the Griffin wick god demands tribute.

Also turn it up to 40w.
 
Yep try more watts, it may be partially vaporised juice in the mouthpiece.

I don't personally have a lot of love for my Griff. Wicks fine, rarely leaks, just seems to generate a lot more condensation than anything else I use.
 
Back
Top Bottom