Help with easy way to taste my juice mix

[kojak]

Hi, don't want to use a new coil ( innokin T22) just to taste juices.
So i was looking at this.


Better suggestions are welcome.
I am not looking for dripping at the moment just tasting new liquids as I make them or buy. What else do I need/type on the cheap (atomizer) and not rebuildable preferred if works out cheap as well.

Another question will the INNOKIN PRISM T22 TANK with a 1.5 coil work on this ? The T22 is 14w fixed power

Cheers Marcus

 

[shiningstar]

This is for ego tanks, the prism is 510 so it wouldn't fit, without using rebuildables your best bet would to keep coils separate for different flavour profiles, depends how many different profiles you're looking at using! What's putting you off rebuildables?

 

[scrumpox]

Your best bet is a small, single coil dripper ... something that can be rinsed and rewicked quickly and easily.
Derringer clones are ideal.

 

[kojak]

@scrumpox and anyone else, so can I screw this or this to my T22 battery (14w fixed). 1.5 ohm wire, or premade, or the wattage is too low to get anything out of the rda, or only/better to the GS Ego II?
What else do I need? Drip tip,.wire, what cotton?

Cheers Marcus

 

[wraith]

A coil that uses a ceramic wick can be rinsed, dried (with a hairdryer if in a real rush) and reused quickly.

Combined with dripping the juice directly onto the coil wick instead of filling the tank you can try a lot of different juices quite quickly. Normally that would be asking for a dry hit and a lung full of cotton smoke but ceramic does not do that.

 

[kojak]

A coil that uses a ceramic wick can be rinsed, dried (with a hairdryer if in a real rush) and reused quickly.

Combined with dripping the juice directly onto the coil wick instead of filling the tank you can try a lot of different juices quite quickly. Normally that would be asking for a dry hit and a lung full of cotton smoke but ceramic does not do that.

Hi, thanks for helping, for what I understand, ceramic coils are power hungry, Sub ohm, ideal if you have a mod that can kick out the power you need. and you are into dripping. Maybe I could use a tank that can take 1.5 ohm ceramic coils on my T22?

I just have a couple of 14 watts T22 - 1.5 ohm coil, 3.5 amp max and was wondering if/what RDA I could get away with just for tasting liquids without messing about changing coils everytime.

Ideally the cheapest solution I was hoping for, was if I could use the T22 somehow with an RDA, but at 14W I doubt it, or something that can fit and work an RDA on a basic cheap mod. It is only for tasting .

I need help with this as you can tell, so forgive me if I am talking sh*t.

Cheers Marcus

 

[Miss Pepper]

A RDA will work on your t22 however you will just need to build higher ohms (ie 1.5 etc) on the coils so it works with the available watts. Just means you can quickly change the wick to test a new flavour.

I wouldnt go with an ego type battery as you wont get out of it what you are used to. I also broke one doing what you are trying to do as they just are not designed for it.

 

[kojak]

@scrumpox and anyone else, so can I screw this or this to my T22 battery (14w fixed). 1.5 ohm wire, or premade,

So these two RDA would fit on the T22 mod right? And considering the wattage at 14W I should be using just a single 1.5 ohms coil (not two set), screwed next to the single air flow hole with the opposite side blocked off.

As mentioned these mods are not designed for dripping, the T22 has the overheating safety feature to protect the battery, this may or not help, for a basic on and off tasting, not a continuos vaping I don't forsee a problem, but again I am just guessing here and would be appreciate if anyone could expand on it.

So I would use this RDA - DERRINGER V3
with this coil 1.5 Ohm 29awg 7 loops
and this cotton - 60x50mm MUJI JAPANESE ORGANIC COTTON
Yes?

Cheers Marcus

 

[Miss Pepper]

@kojak you have done your research and what you are saying sounds like you are ready to do it!

As you say a couple of toots to try the flavour, rest and repeat if need be, single coil (dual coil will knock your ohms down) as you say block the one airflow off if you can, if not shut both sides down to half or three quarters a side to compensate.

If you wanted a go at building pop to

https://www.stealthvape.co.uk/index.php?route=mobile_store/category_list

Buy some wire, throw in some free muji, check out with the rebuildable only postage and you will have enough to keep you going for ages.

 

[kojak]

@Miss Pepper
Thank you, I researched it, but I definitely needed some reassurance from someone with experience and knowledge. You have just provided it, excellent.
Please Miss Pepper or anyone else do add anything else ,tip, etc that would help me, it is my first RDA encounter.

Cheers Marcus