Hello Peeps,
YiHi SX350 v1. No temp control.
1. My ohm meter has gone bad. Most of the time it gives me no reading and sometimes it works like its bullet proof. Need a replacement I guess.
2. Whenever I m building a coil. I cut all the wires and everything and then fire it up on the 350 for some testing. The ohms jump from 1.2 to 2.x and anything in between. Before this started, the ohm count was better than my ohm reader. Now here is the strange part. I put my Squape reloaded W-deck for testing on 7-wraps on 26G. I know this is 1 ohms of just under. Ohm reader said blank and sx350 was jumping all over the place. Put the base into tank, after wicking and it was 1.03ohms. As expected.
Anyone got any advice? The ohm jumping when building coils on 350 is happening on the marquis RDA and Squape D and W decks.
YiHi SX350 v1. No temp control.
1. My ohm meter has gone bad. Most of the time it gives me no reading and sometimes it works like its bullet proof. Need a replacement I guess.
2. Whenever I m building a coil. I cut all the wires and everything and then fire it up on the 350 for some testing. The ohms jump from 1.2 to 2.x and anything in between. Before this started, the ohm count was better than my ohm reader. Now here is the strange part. I put my Squape reloaded W-deck for testing on 7-wraps on 26G. I know this is 1 ohms of just under. Ohm reader said blank and sx350 was jumping all over the place. Put the base into tank, after wicking and it was 1.03ohms. As expected.
Anyone got any advice? The ohm jumping when building coils on 350 is happening on the marquis RDA and Squape D and W decks.
