itaste centre pin issue

[DCR3005]

My itaste vv v3 has been acting weird the past 2 days. On my protank mini's they work fine but they have always read 2.4 when the heads say 1.8 (but I have never checked with a meter).

On my one vision x-jet it has always read 1.9 with a 1.8 coil and always worked with no issue.

Now they still work with the protanks but on the x-jet, it will either show a high resistance such as 9ohms or non.

I thought I needed to pull my pin up to make contact which I tried. I also tried to pull the pin on the x-jet with no luck.

If I do not fully screw the x-jet head on to my battery, about half a turn from fully tight, then it reads 1.8 and works fine.
This makes me to believe that the battery pin is too high or the atty pin is too low, but they both now pushed all the way in and still no luck.

I guess I'm just going to have to bin the x-jet and just use the protanks but I am hoping I can get a good reading with the protanks with new coils.


Also when I upgrade I am now thinking this pin issue is a common problem across all innokin devices? Should I stay away from innokin next time?

 

[DCR3005]

Update:
I thought I would open the x-jet up and remove the coil and screw it in again.
this now reads as 1.4ohms on the itaste with a 1.8coil.

So it's great this is now working, but why would I get such a low reading.
Has all my pushing & pulling been affecting things?

 

[Tots88]

I have a similar problem that I haven't thought about as a problem before. I have an itaste v3 with protank mini 2 and my 2.2 ohm head always reads as 2.5 or 2.6. This has been on 2 heads. Is this a problem with my device or just the in-accuracy of the coil?


Sent from my iPhone using Planet of the Vapes

 

[DCR3005]

I couldn't say for sure but it is a bit weird. My protanks now read 2.1 and my x-jet still reads 1.4.
They work fine so I'm not really worried now but I wonder if anyone else has the S&A e issue on other innokin devices.