Kroma A Coil Problems

[Forward Ghoul]

Am a new user and have been using the T20s for a few months now. I bought a Kroma A and put in a 0.50ohm coil as I don’t go over 14w. I bought it as I am a mtl vaper having used it to stop smoking.

I primed the coil and started it a 8w to biuld up in increments of 5 W every 10 puffs or so.

its burning the coils after only about 12 puffs, it won’t go above 7.5w on one occasion.

can anyone help? I’ve went back to using my T20s for the moment but am wondering if I’ve just wasted forty quid.

 

[Mitz]

Welcome to the forum @Forward Ghoul

Someone will be along to help you shortly.

 

[Simon G]

That comes with a Zenith tank right?

Does it feel like the mod is firing at the wattage you have it set at?

It's hard to diagnose online to be honest, if the cotton is burning then it can't be soaked properly for some reason.

 

[ADDicT]

Hi and welcome

 

[Forward Ghoul]

Am putting in two drops is each hole and leaving it for ten minutes.

 

[Forward Ghoul]

Hi and welcome

Thank you

 

[Forward Ghoul]

That comes with a Zenith tank right?

Does it feel like the mod is firing at the wattage you have it set at?

It's hard to diagnose online to be honest, if the cotton is burning then it can't be soaked properly for some reason.

Yes am starting it at 7w and with two holes exposed in the airflow and it feels just right at these settings

 

[Simon G]

Yes am starting it at 7w and with two holes exposed in the airflow and it feels just right at these settings

Once it's burnt it will stay burnt whatever wattage it's at.

If you have another new coil, give it a really good soaking in liquid, literally pour it into it and don't put it in the tank until you are 100% sure the cotton is fully soaked with liquid. Don't leave it to chance with 'drops' and leaving it to sit, because you will never know that there isn't a little dry patch inside against the mesh or something... Once it's properly primed, wipe it off a little and put it in the tank. Then fill and then vape.... see how that goes.

 

[Forward Ghoul]

Once it's burnt it will stay burnt whatever wattage it's at.

If you have another new coil, give it a really good soaking in liquid, literally pour it into it and don't put it in the tank until you are 100% sure the cotton is fully soaked with liquid. Don't leave it to chance with 'drops' and leaving it to sit, because you will never know that there isn't a little dry patch inside against the mesh or something... Once it's properly primed, wipe it off a little and put it in the tank. Then fill and then vape.... see how that goes.

Thank you, I’ll try that tomorrow and see how it goes. Am happy enough with the T20s in all honesty if it goes wonky again and will just get a refund. Thank you again for the prompt advice