Made my MVP flushhhhh :)

[BAVapes]

How to:
Pry button out with a thin blade
Take top off with T5 torx head screw driver
Unscrew the button board from the top section.
Un-solder the wires from 510 connection.
Put something smaller than the 510 connection inside it and something that will fit around the top on the other end
Smack the crap out of the smaller thing you have on the 510 with a hammer till it breaks loose.
Solder wires to new 510 connection you bought (without huge ego head)
Epoxy the crap out of new 510 to the top of MVP
Make sure the 510 isn't wonky while the epoxy is setting, screw an atty on tight and make sure it sits straight
Screw button board back to top
Screw top back onto body
Put button housing back on
Done

 

[Duffloop]

How to:
Pry button out with a thin blade
Take top off with T5 torx head screw driver
Unscrew the button board from the top section.
Un-solder the wires from 510 connection.
Put something smaller than the 510 connection inside it and something that will fit around the top on the other end
Smack the crap out of the smaller thing you have on the 510 with a hammer till it breaks loose.
Solder wires to new 510 connection you bought (without huge ego head)
Epoxy the crap out of new 510 to the top of MVP
Make sure the 510 isn't wonky while the epoxy is setting, screw an atty on tight and make sure it sits straight
Screw button board back to top
Screw top back onto body
Put button housing back on
Done

Can you do it again but this time video it?

 

[BAVapes]

Can you do it again but this time video it?

Haha no way!

If you are interested in doing it, just follow the above instructions, it is pretty straight forward. All you're doing is taking the top off and replacing the 510 connector.

 

[KulrMeStoopid]

Haha no way!

If you are interested in doing it, just follow the above instructions, it is pretty straight forward. All you're doing is taking the top off and replacing the 510 connector.

I'll send you mine if you will do a video of it

 

[BAVapes]

I'll send you mine if you will do a video of it

You're going to have to bribe me with some juice at least

 

[BAVapes]

A few pics without atty

This is how the device should have been made in my opinion, this and the firing button on the side would have been perfect. Also a few more watts wouldn't hurt!

 

[doobedoobedo]

Smack the crap out of the smaller thing you have on the 510 with a hammer till it breaks loose.

Would you recommend a lump hammer or a sledge hammer?

 

[Grizzly Adams]

Couldnt agree more a lot better looking and more usable

 

[Duffloop]

looks damn cool though - but i usesome ego clearos too so think i'll leave it.

woulda been good to see the innards tho

 

[EntropicVapes]

Ahh that's such a lovely improvement to my OCD eye.