Magnets!!!!

[Raguri]

So you lot.
I have an xxix clone. Now I need magnets for it. Why? As I've already partially collapsed the copper spring. :/

So, these are the sizes I need.

(1) 1/2" od x 1/4" id x 1/16" thick Ring Magnet

- Placed under the delrin Insulator

(1) 15mm x 5mm x 1mm Thick Ring Magnet

- Placed on the back side of the switch

The back side of switch one, I could use a Nemmie magnet. Its the other one I'm having problems with.

Ps. I have already tried guys...

 

[keepitgoin]

​Hiya, google "Guys Magnets" you should find what you need, they come in Metric sizes though, AND different strengths!

 

[ambivalent]

You could try the 10mmx8mmx2mm size from guys, it might fit.

 

[Raguri]

​Hiya, google "Guys Magnets" you should find what you need, they come in Metric sizes though, AND different strengths!

Have already tried guys xD first place I looked. The end of the text says that, but can see now it could easily be misunderstood

 

[keepitgoin]

Ooops, sorry I just re-read y6our original post

 

[Raguri]

Seedy
Any ideas?

 

[RicModMaker]

Let me have a measure up. I might have something. Gimme 5 mins

 

[RicModMaker]

I've got some ring magnets that have od15, id4 and are 2.5mm thick. Not sure if you can mill it down but I'll send you a couple if you can. It is countersunk so if you can mill the countersunk side, it'll be a normal ring.

 

[Raguri]

I've got some ring magnets that have od15, id4 and are 2.5mm thick. Not sure if you can mill it down but I'll send you a couple if you can. It is countersunk so if you can mill the countersunk side, it'll be a normal ring.

Bugger! No worries
It's the width that's hard for me, as it is held in place by a bit of Delrin so it is rather snug may try and look for 1mm magnets, and use some putty to hold it Haha.
Plus, no mill access anymore and sod sanding them. Tried that before. XD

 

[RicModMaker]

I've got a mill. Let me see if I can mill 1 down