My 1st diy 18650 pipe

[Crewella]

Trimmed, rough sanded and drilled out by hand.
View attachment 191041View attachment 191042View attachment 191043
Decided on a flat bottom base to hopefully balance itself.

So far, so GREAT!

 

[bellyman]

Watching with interest [emoji106]

 

[Jon The Vape]

For the tube I used a smpl 22mm mech.

 

[Jon The Vape]

To make a 510 connection I have used a 22mm heat sink which screws into the smpl tube. Ground down to reduce length.

 

[Jon The Vape]

Attached to the heatsink is a 510 positive pin from a clone rda

 

[AJT]

Apple wood I guess will always have a lovely smell about it..bonus.

 

[Jon The Vape]

Here's the heatsink with 510 screwed in place. Ready to solder.

 

[Jon The Vape]

Soldered and ready to drop in place.

 

[Jon The Vape]

Apple wood I guess will always have a lovely smell about it..bonus.

When I drilled out the tube using forstener bits it had a nice aroma to it. [emoji4]

 

[Jon The Vape]

Next stage
Used a varitube 22mm spring loaded 510 connector from Stealthvape.