My first box build

[sjf]

Hey guys I have now built my first box so thought I would share. It uses the same chipset as as the hexohm v2 & v2.1.
Specs are as follows

Hammond 1590g box
Various magnets
22awg multi strand copper silicone wire
16awg multi strand copper silicone wire
Fat daddy 510 v3 smooth top
Duel 18650 keystone sled
13mm ss domed switch
1k Potentiometer
Okl t20 chip
Couple resistors
Heat shrink

There are various pictures through the built allot of pictures not included

Hammond box was filed down and polished to get rid of the lean but needs re polished

Chip has been heat shrunk all joints are soldered

The finish on the box did not get my full time and attention to be honest so does have some imperfections. It was a case of I want it finished lol (next one will be prefect)

I choose not to fit volt meter and master switch as some people do.

Please let me know what you think criticism is always welcome positive or negative

 

[domejunky]

pretty tidy - better than my recent first box...

 

[sjf]

pretty tidy - better than my recent first box...

Thanks mate its working great so very pleased with it

 

[RicModMaker]

Good man. Looks tidy

 

[x0dinx]

Nicely done that.

 

[dave2010]

Tasty

 

[parkerfresh]

I was in the process of building a very similar box, just needed to verify which chip and pot to go with...was leaning more towards parallel, but still need to figure some stuff out.

Looks very tidy for such a tight build. You've given me a bit of motivation to crack on

 

[sjf]

Good man. Looks tidy

Cheers mate

 

[sjf]

Nicely done that.

Cheers mate

 

[sjf]

I was in the process of building a very similar box, just needed to verify which chip and pot to go with...was leaning more towards parallel, but still need to figure some stuff out.

Looks very tidy for such a tight build. You've given me a bit of motivation to crack on

Well this one is the murka okl t20 chip if you use this chip you will need to wire batteries in series as the input voltage of the top of my head is 6-14volts. I have the spec sheet for the chip if you need it. I went for a 1k ohm pot @13mm as I like the look of it with the arrow other people use the 10mm one as the terminals are at 90°from the pot but the one I used is sealed and the terminals can be bent to 90° without damaging it.

It is neat but I can assure you there was plenty of f####g and c##ting going on when trying to work out wire orientation so it got put in the cupboard and left. Then the other night decided to get it out couple hours it was done sometimes you just need to walk away and cone back to it lol