My vapes being weird

[Hmmmmm]

Hey guys/girls, I have a puma 200W vaporstorm, the other day it seemed to only drain 1 of the batteries. I put some fully charged batteries in it and it did the same thing again. I ordered new batteries from fogstar fully charged them and not the mod wont power on. I put the batteries into another mod i have the voopoo drag and the fogstar batteries are fully charged no problems. the partially drained batteries power up the drag. Am I doing something wrong? Is my mod seen better days?

 

[nickp87]

I know knowing about electronics etc, but sounds top me like an issue with the board/circuitry.

It would be in the bin if it were me unless the mod was expensive

 

[Hmmmmm]

I know knowing about electronics etc, but sounds top me like an issue with the board/circuitry.

I have tried to plug it into the computer to up date it. But when the cable is plugged in with no batteries in the mod doesn't react at all. Pretty frustrating in honesty.

 

[Miss Pepper]

I never got to the bottom of it with one of my mods, always discharged one a lot quicker than the other, at times one was nearly fully charged the other nearly fully flat.

In the end I got a new mod and new batteries!

 

[Hmmmmm]

I never got to the bottom of it with one of my mods, always discharged one a lot quicker than the other, at times one was nearly fully charged the other nearly fully flat.

In the end I got a new mod and new batteries!

I got the batteries in charge inside the mod now to see if it makes any difference, just in case my external charger is the issue. 1 battery is 100% and the other is 30%, the difference is ridiculous.

 

[Cozy]

I got the batteries in charge inside the mod now to see if it makes any difference, just in case my external charger is the issue. 1 battery is 100% and the other is 30%, the difference is ridiculous.

If the batteries are fine in the drag then it points to the mod being faulty, might be worth giving the battery terminals on the mod a clean but other than that I'm not sure

 

[Steve.]

I never got to the bottom of it with one of my mods, always discharged one a lot quicker than the other, at times one was nearly fully charged the other nearly fully flat.

In the end I got a new mod and new batteries!

I would have to do the same as you, just could not put up with it.

 

[Mr Ripple]

I have tried to plug it into the computer to up date it. But when the cable is plugged in with no batteries in the mod doesn't react at all. Pretty frustrating in honesty.

Take batteries out.
Hold down fire button when you plug it into your pc.
If its firmware upgradable your pc should recognise it.

 

[Tazz]

Sounds like its putting a big load on one battery then. Not cool for a dual battery device really. Failing the upgrade attempt above, I'd ditch it without hesitation.

 

[Miss Pepper]

I got the batteries in charge inside the mod now to see if it makes any difference, just in case my external charger is the issue. 1 battery is 100% and the other is 30%, the difference is ridiculous.

Never made a difference with mine. Somehow the 'battery usage' and 'battery charge' just didn't sync up.