New Mod Help

[D-O-A]

Hello,

I have a Vapour Storm Puma Mod 200W, & Horizon Falcon Tank

I just need help with the settings

I have M1 M2 and M Triple coils and i am unsure if these are best set to Ti Ni or SS i thought it would simply set it up to M1 or M2 setting but i have been informed this is a manual setting i have to set?

That was confusing just writing it out hope my problem makes sense and someone can help?

Cheery Pip

 

[EmbraSewerRat]

Hello,

I have a Vapour Storm Puma Mod 200W, & Horizon Falcon Tank

I just need help with the settings

I have M1 M2 and M Triple coils and i am unsure if these are best set to Ti Ni or SS i thought it would simply set it up to M1 or M2 setting but i have been informed this is a manual setting i have to set?

That was confusing just writing it out hope my problem makes sense and someone can help?

Cheery Pip

Don't know the kit, but the mesh in the coils is probably not to be used in the Temp Control setting. So ignore thon 'Ti Ni or SS' for now. It should just screw onto the top of the mod and off you pop.

If the mod is like my ye olde IPV4, the M settings can be programmed in manually for settings you like. I'd highly advise you go watch a few youtubes o the kit to see whats what. Or have a swatch at the manual that should have came with it.

 

[MrDJ]

Hi and welcome to the planet.
Set to Wattage/power mode only.
TC temperature control is for nickel, titanium coils only and stainless steel can be used in both. I've vaped for 4 years and only tried TC twice. For the M coils you have it's wattage all the way.

 

[D-O-A]

Hi and welcome to the planet.
Set to Wattage/power mode only.
TC temperature control is for nickel, titanium coils only and stainless steel can be used in both. I've vaped for 4 years and only tried TC twice. For the M coils you have it's wattage all the way.

Don't know the kit, but the mesh in the coils is probably not to be used in the Temp Control setting. So ignore thon 'Ti Ni or SS' for now. It should just screw onto the top of the mod and off you pop.

If the mod is like my ye olde IPV4, the M settings can be programmed in manually for settings you like. I'd highly advise you go watch a few youtubes o the kit to see whats what. Or have a swatch at the

 

[D-O-A]

Thank you for your help, truly appreciated.

 

[D-O-A]

Hi and welcome to the planet.
Set to Wattage/power mode only.
TC temperature control is for nickel, titanium coils only and stainless steel can be used in both. I've vaped for 4 years and only tried TC twice. For the M coils you have it's wattage all the way.

 

[D-O-A]

Ahh Ok, thank you for that I was getting truly confused. I’ve been burning through coils on my old mod hopefully these coils are worthy of the hype.

 

[Cozy]

Make sure you break the coils in, prime them by putting some juice in the cotton holes on the outside of the coil, fill tank let sit for 10 mins then start off at 25w, few puffs then increase by 5w each time till you get to your preferred wattage, I usually run the falcon at around 70w

 

[D-O-A]

Yeah I learnt that mistake, thank you for the advice.

 

[davelin83]

I have always stayed away from temp mode as I found it pointless. Using power mode always seemed simple and affective