New Yachtvape Pandora Bellcap

[ZT]

I’d be interested in some wicking tips too. I’m not too bad with it, but have had a few dry hits occasionally which is very annoying to say the least.

Bell cap or no bell cap?

 

[rew]

Bell cap or no bell cap?

To bell or not to bell. That is the question.

 

[Tobytyke]

Bell cap or no bell cap?

With bell cap. Seem to struggle with wicking when it come to decks like these. I.e poking the wick into those type of ports. Probably got too much stuffed in there.

 

[ZT]

With bell cap. Seem to struggle with wicking when it come to decks like these. I.e poking the wick into those type of ports. Probably got too much stuffed in there.

I would say that is almost defo the case - it needs to almost look like there is not enough.

2.5mm diameter coil and wick cotton still able to move with only a slight resistance in it.

Do not use cotton bacon or anything else that swells too much - muji is king with these puppies

 

[Tobytyke]

I would say that is almost defo the case - it need to almost look lime there is not enough.

2.5mm diameter coil and wick cotton still able to move with only a slight resistance in it.

Do not use cotton bacon or anything else that swells too much - muji is king with these puppies

Thanks pal, Will give it a shot. I only use those Labo puff squares & 2.5mm dia round wire coil. Think I’m ok with the cotton through the coil, I’ll rake the ends out a bit & try not to put too much in there. BTW, I cut the cotton level with the deck, that sound about right?

 

[ZT]

Thanks pal, Will give it a shot. I only use those Labo puff squares & 2.5mm dia round wire coil. Think I’m ok with the cotton through the coil, I’ll rake the ends out a bit & try not to put too much in there. BTW, I cut the cotton level with the deck, that sound about right?

Im going to take some pictures in a bit - i pull the cotton straight out from the coil and looking from the too cut halfway between the outside of the atomiser and the inner silver ring - the cotton should be above the flow holes in the wells … not covering them IMO

 

[ZT]

To put it another way - dont fill the juice wells with cotton, they are juice wells not cotton wells

 

[Tobytyke]

Im going to take some pictures in a bit - i pull the cotton straight out from the coil and looking from the too cut halfway between the outside of the atomiser and the inner silver ring - the cotton should be above the flow holes in the wells … not covering them IMO

Thanks @ZT most helpful

 

[ZT]

Thanks @ZT most helpful

Let me know how it goes down

 

[ZT]

Ok images of standard round wire coil position and cotton lengths etc that i use i cut the cotton to the inner side of the airflow ring