NextGen clone - airflow?

[skinku]

Handy and fortuitous this thread is.
300 mesh is on its way to my inexperienced hands.
Thanks for the tips.

 

[andky]

Finally managed to sit down and spend a bit of time setting this up.

Still to actually nail the build - hotspots and shorting all over the gaff - but got it working (fairly) well today.

Flavour is divine! Powwow & Chiricahua never tasted better.

Every now and again I get a bit of a metallic taste...which I believe might be down to mesh/wire shorting?

Time will tell if I will be master of the mesh, but it's a good old challenge.

 

[Jugg1es]

The metallic taste is probably a small hotspot, normally it'll occur on the edge of the mesh tube.this will probably go as the mesh beds in, you'll probably need to have a little nudge of the coil at the end of each tank for a few days.
That nextiny clone is definitely on my next order I think

 

[andky]

Nice one @Jugg1es I'll give that a go.

It's a really nice vape (when not getting the metallic vibe). [emoji38]

 

[andipandi]

First mesh build and toot on a nextgen (FT clone), wasn't sure at first but this thing could become as addictive as Tennents Super once was for me (a long time ago).

 

[andky]

Tennents Super...ooft - been a while since I've supped that! [emoji2]