Profile RDA Problem

[Martvb60]

Sorry, my bad, the slots are in the base and lugs inside the cover as @Cozy said. I do mine the same as @Cozy push the cover on while the base is on a mod and twist clockwise while pushing down. It can be a bit tight when they are newish until the O rings give a bit with use.

 

[LordOdin]

@Cozy tried everything and the last few millimetres won't go any further, i tried my Profile 1.5 and had no problem with that it's just not wanting to go. it's not leaking so i can vape ok with it, using it on my topside single with no problems, might try again when i have more patience. Thanks i appreciate your help and advice.

 

[LordOdin]

@Cozy and @Martvb60 I thought i would give it one last try and the fucker popped on like i hadn't been having problems with it. Hope it's better when i have to put a new build in it lol. Big Thanks though, it wasn't going to give in lightly lol.

 

[Cozy]

@Cozy and @Martvb60 I thought i would give it one last try and the fucker popped on like i hadn't been having problems with it. Hope it's better when i have to put a new build in it lol. Big Thanks though, it wasn't going to give in lightly lol.

No worries mate, yeah once base is fully would in, it gives you the ability to rotate top cap, do it slowly while pushing down and it will find the slots and just click down, had the same issue as you before, little bit of juice on oring of base or inside the top cap eases it over, the 1.5 seems to do this alot easier

 

[Cozy]

Additionally add the top cap minus the drip tip while doing it, this will stop you accidentally deforming the mesh while pushing down on it, I've done that before on a fresh build!!!

 

[LordOdin]

This is how it was at first

Then after faffing about.

Though looking at the second picture it still looks a bit skew wiff lol.

 

[LordOdin]

Straightened it out now so alls good @Cozy, Big Thanks again.