Pulse BF Squonk Mod w/ Druga RDA

[bigearljf]

Does this RDA work fine with the Pulse? Sorry for my stupidity, just need to clear this up.

 

[cindy99]

Should be fine @bigearljf [emoji106]


Welcome to the Planet! [emoji4]

 

[gravystain]

As already stated you should be fine with that set up but if this is your first mech/rda set up then there is also a few other things to bare in mind to stay vaping safe, don't build any lower than 0.2 ohms resistance, use a good quality battery, Sony vtc5a or Samsung 25r will be just fine, always test fire your build on a regulated mod before putting it on a mech and if your unsure of anything then ask on here there is plenty of vaping knowledge and friendly people to help you out...

 

[bigearljf]

As already stated you should be fine with that set up but if this is your first mech/rda set up then there is also a few other things to bare in mind to stay vaping safe, don't build any lower than 0.2 ohms resistance, use a good quality battery, Sony vtc5a or Samsung 25r will be just fine, always test fire your build on a regulated mod before putting it on a mech and if your unsure of anything then ask on here there is plenty of vaping knowledge and friendly people to help you out...

Awesome. Thanks for your reply. Have Samsung 25Rs so good to go on that end. Just a bit unsure about what wire to use...

 

[gravystain]

Awesome. Thanks for your reply. Have Samsung 25Rs so good to go on that end. Just a bit unsure about what wire to use...

It takes abit of experimenting to find the right wire and build for your vaping style but on the set up you have I would use some 24 gauge kanthal, what coil resistance are you looking for ??

 

[bigearljf]

Please pardon my limited knowledge regarding all of this. I am trying to learn, I promise. I've set up the pulse with my druga and am running 1 Samsung 18650. Think I have dual alien claptons installed at the moment. I've tried it, but the mod only seems to fire very lightly. I can get a very small vape out of it.

Again, excuse my explanation there...

 

[nwhornet]

Depending on what ohm your coils are there may not be enough power coming off the battery. 2x Aliens will need a fair bit of oomph to get to temp. Also what wire type? I only use Sony VTC5A's in my mech squonkers due to the higher amp rating & allowing lower ohm builds.

 

[Bazz_74]

Too much metal in the coils for a single battery to get up to temperature, in all my RDA's for mechs (including the Druga) I use flattened Ni80 wire, 6 wraps 3mm ID comes out at 0.25 ohms as a dual coil build.

This si the wire I use and I highly recommend it: http://www.wireandstuff.co.uk/produ...-Made-Flat----10-Metre-Spool-467.html#SID=125

 

[sidders]

In my mechs I just use simple ss316 round coils around 0.20-0.25. Aliens take longer to ramp up

 

[bobsyeruncle]

Too much metal in the coils for a single battery to get up to temperature, in all my RDA's for mechs (including the Druga) I use flattened Ni80 wire, 6 wraps 3mm ID comes out at 0.25 ohms as a dual coil build.

This si the wire I use and I highly recommend it: http://www.wireandstuff.co.uk/produ...-Made-Flat----10-Metre-Spool-467.html#SID=125

Just ordered some.