Question

[rob71]

Hi i am new to mixing my own juice i am trying to do 70/30 pg/vg mix.
This is quantities i used.
pg 5.35ml
vg 2.25ml
flav 1.0ml blueberry
nic 1.4ml ( nic is vg base)

so it should have given me a 70./30 10mg mix have i got this right or am i totally wrong.
thank you
rob

 

[lndiscalling]

What strength is the Nic?

Would also recommend getting some mixing calculators / apps, I use these :-

 

[bob]

Hi i am new to mixing my own juice i am trying to do 70/30 pg/vg mix.
This is quantities i used.
pg 5.35ml
vg 2.25ml
flav 1.0ml blueberry
nic 1.4ml ( nic is vg base)

so it should have given me a 70./30 10mg mix have i got this right or am i totally wrong.
thank you
rob

here you go pal very easy calculator to use. e-Liquid Calculator :: New recipe we would have to know what strength nic you are using pal?
type everything in the boxes and the result/measurements are worked out for you at the bottom.

 

[rob71]

sorry should have said nic is 72mg vg base

 

[Ment]

sorry should have said nic is 72mg vg base

The nic strength is irrelevant to your question, but assuming the flavouring is PG based, you have 63.5/36.5 PG/VG. Close enough, people make too much fuss about this.

 

[bob]

The nic strength is irrelevant to your question, but assuming the flavouring is PG based, you have 63.5/36.5 PG/VG. Close enough, people make too much fuss about this.

i think it does make a difference if its vg or pg if its 36 or 72 you have to alter your vg/pg in order to get an accurate dilutant

 

[oldhippydude]

I mix 100ml batches and save a bit of time by pre mixing my vg/pg at 80/20 in 500ml batches I use a low level of flavour compared to most people normally 5% or 6%.Depending on what I will vape it in my nic strength may vary and thus I neither know nor care what my exact vg/pg ratio is, so I am more like ment than bob on this one.
Some people like precision others are happy with rough and ready.You work out what suits you.

 

[Ment]

i think it does make a difference if its vg or pg if its 36 or 72 you have to alter your vg/pg in order to get an accurate dilutant

Of course if the op had given a target to work to the strength would have been relevant, but as he gave figures adding up to 10ml it didn't matter. His final mix could have been 3mg/ml or 6 or anything and it wouldn't change the VG/PG ratio.