RDA Coil issue

[Mr Ripple]

Yep sure am, takes like 4 timeouts to get them go glow though :/ I'll check and see how it reads them separately

If you then give the post screws a little tighten afterwards and its still the same then something is touching somewhere it shouldnt or you have a stray off cut of wire inside somewhere.

 

[AMCoil]

I removed the wick and they read at 0.24 now and seem to heat up much better now, reckon I should re wick and try em out?

Edit: single coil setup reads as 0.47 n heats up better on it's own but it's still the wrong resistance fml

 

[AMCoil]

Rewicked, maintained at 0.24ohms (still higher than it should be right?) But its vaporising the liquid now and doesnt feel like my atty is a blacksmiths crucible in 5 seconds now

Edit: Still get ridiculously hot in about 5 draws at 55w, think I'll try some different coils and see where It stands and go from there

 

[Mr Ripple]

Rewicked, maintained at 0.24ohms (still higher than it should be right?) But its vaporising the liquid now and doesnt feel like my atty is a blacksmiths crucible in 5 seconds now

Edit: Still get ridiculously hot in about 5 draws at 55w, think I'll try some different coils and see where It stands and go from there

Try positioning the coils closer to the airflow holes so the air is hitting the bottom of the coils.
You want to be able to see no more than the bottom half of the coils through the airflow holes.

 

[AMCoil]

Try positioning the coils closer to the airflow holes so the air is hitting the bottom of the coils.
You want to be able to see no more than the bottom half of the coils through the airflow holes.

The airflow on this atty seems to be setup so it hits the entire coil if it's open all the way but I can try install some so they're abit higher, appreciate the input alot mate thanks for responding as much as you have!