Review of the Aga-T+ ( Aga-T Plus ) from www.esmokeuk.co.uk

[ZT]

errrr ....

I kinda put the mesh next to the aga .. cut the height ... and then cut across somewhere between 2 and 3 cm .. its no exact science for me I'm afraid!

 

[mattmee]

cheers

 

[Bryan123456]

I just did mine with silica wick and have started to put sleeving over these where I coil - the flow of e liquid is just - better. I think my coiling onto bare wick was too tight and causing dry hits. It is an improvement over the AGA-T - the main one being the push on cap - lining up the air hole is easier and more adjustable. It looks sleeker too and is a few mm shorter. The only complaint I have is one that ZT highlighted in the excellent review - the top nut on the earlier version was both easier to use and easier to slip your wire over. Great product.

 

[ZT]

Brian .. when you do your sillica wick .. do you put an unbent paperclip nex to the silica and wrap around both then pull the paperclip out? I find this stops strangulation issues

 

[OccultScientist]

Brian .. when you do your sillica wick .. do you put an unbent paperclip nex to the silica and wrap around both then pull the paperclip out? I find this stops strangulation issues

I find the best way to deal with those pesky strangulation issues is to not put the wick around your neck

 

[Bryan123456]

I find the best way to deal with those pesky strangulation issues is to not put the wick around your neck

"An orange, a plastic bag and a piece of string. What could possibly go wrong?"

 

[Bryan123456]

Brian .. when you do your sillica wick .. do you put an unbent paperclip nex to the silica and wrap around both then pull the paperclip out? I find this stops strangulation issues

I have recently started using silicone sleeving and it helps hugely - it is a bigger diameter than the wick and allows me to wick tightly - getting nice neat coils - without strangling the flow of juice through the coil.

 

[ZT]

Sounds good .. you just reminded me .. I meant to order some from stealth today ...