RIFT aio issues with firing

[G1NGE]

Hello everyone , this is my first post on here,

I have recently purchased a RIFT aio. Crème de la crème as they say. And I ordered an ether 2 which just arrived for it and I’m sitting here setting it up and have built the coil up and wicked it. However as I have now put it into the Boro tank and installed it in the vape to test fire I get a near millisecond of it firing and then I get the red word temp flash over the ohs readings and then it stops. I have tinkered with all the settings to no avail. Can someone please save me from this misery.

Kind regards,

G1NGE

 

[Rickster]

Hello everyone , this is my first post on here,

I have recently purchased a RIFT aio. Crème de la crème as they say. And I ordered an ether 2 which just arrived for it and I’m sitting here setting it up and have built the coil up and wicked it. However as I have now put it into the Boro tank and installed it in the vape to test fire I get a near millisecond of it firing and then I get the red word temp flash over the ohs readings and then it stops. I have tinkered with all the settings to no avail. Can someone please save me from this misery.

Kind regards,

G1NGE

To exit temperature control mode on a DNA 60 chip, simply navigate to the settings menu on your device and select the "Power" option instead of the "Temperature Control" option; this will switch your device back to standard variable wattage mode.

 

[G1NGE]

To exit temperature control mode on a DNA 60 chip, simply navigate to the settings menu on your device and select the "Power" option instead of the "Temperature Control" option; this will switch your device back to standard variable wattage mode.

Hi Rick, what “power option are you on about exactly ?

 

[Rickster]

Hi Rick, what “power option are you on about exactly ?

VW

 

[Rickster]

This should also work To disable the temperature protection entirely, adjust the limit up to 600 degrees, then press the UP button one additional time. The temperature limit will read OFF.

 

[G1NGE]

I’m still having the same issue I managed to complete the second solution you gave but can’t find any of the setting mentioned in the first solution ?

 

[Rickster]

https://downloads.evolvapor.com/dna60.pdf

 

[G1NGE]

I really don’t think the solution is in there
I fire the decide it then flashes fire where it should where the ohs are displayed but then immediately goes to red writing say temp
Then refuses to fire

Seriously have struggles and my local vape shop is useless when it comes to this sort of thing hence turning to the group

 

[G1NGE]

Still seeming to have this issue even when in VW mode

 

[ripe_plantain]

Check your coil is not loose or touching the cap