Scar RDA won't fire whatsoever

[Puncake]

Alright so I got my first RDA which happens to be a Scar RDA on a Sigelei Telescopic 13.
The thing is 0.8ohm resistance, I've tried firing it using Ultrafire BRC18650 3000mAH and a Trustfire TF18350 1200mAH, both didn't do a single thing, no fire, no heat, no nothing.
My other atomizers like regular CE4s and both my Vivi Nova and Mini Vivi Nova fire very fine, so my question is, is my center pin faulty? (unlikely) or is it my batteries? I know they're unsafe and whatnot, but aren't they supposed to at least fire?

 

[Puncake]

Sorry for double post, forgot to add its in dual coil mode 0.8ohms, so I'm guessing if I remove one coil the atty would be 1.6ohms?

 

[RicModMaker]

Yep. It sounds like the mod has a minimum ohm restriction.

 

[Puncake]

Yep. It sounds like the mod has a minimum ohm restriction.

So what do you suggest?

 

[cheersm8]

Correct me if I am wrong as I don't own a #13. I believe that on the #13 the positive pin is adjustable? If so, then it sounds like you need to adjust the pin so it makes contact with your Scar.

 

[Puncake]

Correct me if I am wrong as I don't own a #13. I believe that on the #13 the positive pin is adjustable? If so, then it sounds like you need to adjust the pin so it makes contact with your Scar.

It is adjustable, and its also fully screwed in

 

[Purplefowler]

My scar will only connect on my provari but not on my roller, which is what I bought it to use with. It's bloody annoying!
(I know I can unscrew the contact but I haven't got round to it yet!)

 

[u8myufo]

I have found that my scar will work on some mods with no problems and a couple of others it did not. As far as I am aware the positive pin on my scar does not unscrew, however you can get a small flat screwdriver and go around the pin gently and winky wanky woo it out a bit, enough to make contact.

 

[Purplefowler]

I have found that my scar will work on some mods with no problems and a couple of others it did not. As far as I am aware the positive pin on my scar does not unscrew, however you can get a small flat screwdriver and go around the pin gently and winky wanky woo it out a bit, enough to make contact.

I've always enjoyed abit of winky wanky woo

 

[Puncake]

Alright so turns out after removing one coil and making it single coil instead of dual coil, theoretically the resistance should be 1.6ohms instead of 0.8 and now it fires (not every single time though).