Sigelei 150w
- Thread starter krismaguire
- Start date
darren_gill
Postman
- Joined
- Jan 29, 2015
- Messages
- 121
Is 150w not a tad overkill? If you're going to be moving on to super low ohm coil builds on an rda in the future then I would get 150w but if it's just for use with a subtank / atlantis or any other tank then you're usually restricted to 30w - 40w.
alwayslit
Achiever
- Joined
- Feb 12, 2015
- Messages
- 2,243
Horizon Arctic would be the atty for this mod if you didn't want to do any builds.
Ive been using a sigelei 150 for a while now my only niggles are that my atties have scratched the paint off the top and that the 0.1 increments can be a bit annoying but im splitting hairs really. its been a solid mod. dropped it a couple of times still works perfectly and the threads are high quality.
most of the time ive got a goblin or a dripper on it.
the only reason i got it over the 100w is sometimes i like to vape at 80w ish and the 150 gives me a good head room over that if i want to experiment with different builds. the 100w is plenty really, but the 150 isnt as stressed as its nowhere near its peak.
most of the time ive got a goblin or a dripper on it.
the only reason i got it over the 100w is sometimes i like to vape at 80w ish and the 150 gives me a good head room over that if i want to experiment with different builds. the 100w is plenty really, but the 150 isnt as stressed as its nowhere near its peak.
MrTeaTime
Legend
- Joined
- Jul 14, 2013
- Messages
- 13,933
Do you drive your car at its maximum speed? Do you red line it in every gear? 
I personally never run my batteries at there full capacity, or my mods at full pelt either.....if your not running your mods at max power and red-lining then you will preserve your device.....my 30w hana never runs at more then 20w and my ipv2s never runs at more then 40w and that is only rarely......
And in my mechs, i never go lower then 1.2ohms on a vtc4 or samsung high drain.....
I know that what i do is safe, and that im not "pushing the envelope" of my batteries or devices....
So, yep, even though i might get a sigelei 100w v2 or 150w, the chances of running it at anywhere near that are slim......it would purely be for battery life, or the form factor of "i like the look of that"
I personally never run my batteries at there full capacity, or my mods at full pelt either.....if your not running your mods at max power and red-lining then you will preserve your device.....my 30w hana never runs at more then 20w and my ipv2s never runs at more then 40w and that is only rarely......
And in my mechs, i never go lower then 1.2ohms on a vtc4 or samsung high drain.....
I know that what i do is safe, and that im not "pushing the envelope" of my batteries or devices....
So, yep, even though i might get a sigelei 100w v2 or 150w, the chances of running it at anywhere near that are slim......it would purely be for battery life, or the form factor of "i like the look of that"
Similar threads
