Squonk Check

[eyeball kid]

I do indeed mate, I've just put the Derringer on and the very slight overhang is getting too much. Any suggestions?

The new chalice 4 comes to mind. There's a clone if the genuine is a little pricey (Todd's recently reviewed it). Obviously the strike bit that's pure mtl. Or look at hellfire. The viper ect.

 

[mannikon]

https://www.fasttech.com/products/8548900

Anyone eyeballed this? Mesh but could it use cotton, I don't understand the deck as I've never delved into mesh but this cheap little thing squonks and comes in four finishes. Damned if I can see what it's "styled" on ...

 

[Bazz_74]

https://www.fasttech.com/products/8548900

Anyone eyeballed this? Mesh but could it use cotton, I don't understand the deck as I've never delved into mesh but this cheap little thing squonks and comes in four finishes. Damned if I can see what it's "styled" on ...

Saw a Grimm Green video on something similar the other day, it uses mesh as the coil, still uses cotton as the wicking material. Cthulu attie i think.

 

[mannikon]

Saw a Grimm Green video on something similar the other day, it uses mesh as the coil, still uses cotton as the wicking material. Cthulu attie i think.

Yes it's a clone of the Cthulhu Ceto, they had to relist it as CT.
Trying to decide if it could be used without mesh ... will read up on the original.

 

[mannikon]

So I missed all the noise all over the net about the Ceto - ordered now, looks enormous fun!
Will try the clone as well when it comes in stock.

 

[eyeball kid]

So I missed all the noise all over the net about the Ceto - ordered now, looks enormous fun!
Will try the clone as well when it comes in stock.

It's along the lines of the new taifun. Not sure about flavour but it should be bloody cloudy.

 

[Bazz_74]

So I missed all the noise all over the net about the Ceto - ordered now, looks enormous fun!
Will try the clone as well when it comes in stock.

Going by what Grimm Green says it looks as though you need a good 100 watts+ to get this going, so it's not going to cut it on most mech squonkers, and i bet that cotton can hold quite a few ml's of juice too.

 

[mannikon]

Going by what Grimm Green says it looks as though you need a good 100 watts+ to get this going, so it's not going to cut it on most mech squonkers, and i bet that cotton can hold quite a few ml's of juice too.

Think I watched that - chap in huge glasses? Said there were no dual cell squonk mods?
100W will be fine on my Drones and DB160s.
As I say it looks fun and if taste is good it may well become part of my arsenal.
Juice wise, could be a guzzler ...
(he says as he refills 11ml squonk bottle and 12ml RDTA )

 

[eyeball kid]

Le Concorde. Tried with a 1.2 ohm, 2.5mm, 26awg yesterday and found it a little disappointing. A 0.8 24 awg is much better. Getting serious flavour now.

 

[tootingyoda]

Forgot I had this dinky thing. No overhang (yay), but needs a beauty ring really. Time to cut the grass methinks.